D-Link DFE-530TX User Manual page 16

DFE-530TX Ethernet/Fast Ethernet Adapter for PCI Bus
2. If your order does not include the Boot ROM option, go ahead
to Step 3. If your order includes the Boot ROM option, then
install the Boot ROM Chip by plugging the chip into the Boot
ROM Socket on the DFE-530TX card. The notched end of the
Boot ROM Chip must be aligned with the notched end of the
Boot ROM Socket (opposite alignment will cause destruction of
the Boot ROM Chip).
3. Insert the contact edge of the DFE-530TX card into the
connector of any available PCI Bus Master expansion slot.
Press the card firmly into the connector and ascertain that the
card • contacts are fully seated in the connector.
4. Install the bracket screw which secures the card to the computer
chassis.
5. Replace the computer • chassis cover.
6. Reconnect the computer • power cord, and switch computer
power on. If the BIOS section of your computer • boot program
is Plug and Play compliant, then at power-up the BIOS will
automatically configure any newly installed DFE-530TX
adapter.
NOTE: Due to a fault in some Plug-n-Play BIOS programs, it
happens occasionally that a newly installed adapter is
assigned an Interrupt Number which is already assigned to
another device. In such a case, the conflict of Interrupt
Number will cause faults in the behavior of both devices.
Then it is necessary to run the CMOS Setup utility, and
manually assign a non-conflicting Interrupt Number.
8 Installation