Remote Control - Yamaha NP-S2000 Owner's Manual

Remote control

1
2
SOURCE
DIMMER
3
REPEAT
4
5
6
7
RETURN NOW PLAYING
8
9
VOLUME
■ Using the remote control
Aim the remote control directly at the remote control sensor on this unit during operation.
0
DISPLAY
A
SHUFFLE
B
MEMORY
PRESET
SETUP
HOME
C
D
ENTER
AMP
E
MUTE
INPUT
Remote control sensor
OFF
30
SOURCE
DIMMER DISPLAY
REPEAT SHUFFLE
MEMORY
PRESET
SETUP
RETURN NOW PLAYING HOME
ENTER
AMP
VOLUME
MUTE
INPUT
1 Remote control signal transmitter
Transmits infrared signals.
2 SOURCE (
P.14)
Selects a source type.
3 DIMMER
Adjusts the brightness of the front panel display.
4 REPEAT (
P.15)
Switches the repeat mode (repeat all, repeat single, off).
5 MEMORY (
P.15)
Turns this unit to the preset mode.
6 PRESET (
P.15)
Selects a preset number.
7 SETUP (
P.17)
Shows the setup menu in the front panel display.
8 RETURN (
P.14)
Shows the upper-level menu in the front panel display.
9 Cursor buttons/ENTER (
Use the cursor buttons to select an item and ENTER to
confirm the selection, or control the playback functions.
0
(power) ( P.9)
Switches this unit between on and standby.
A DISPLAY (
P.15)
Switch the playback information shown in the front panel
display.
B SHUFFLE (
P.15)
Switches the shuffle mode (on, off).
C HOME (
P.14)
Shows the top-level menu in the front panel display.
D NOW PLAYING (
Shows the playback information in the front panel display.
E Amplifier control buttons
Control the corresponding functions of Yamaha amplifier.
For details, refer to the manual of your amplifier.
y
These buttons may not work on some Yamaha amplifiers.
LINK
Within 6 m (20 ft)
30
CONTROLS AND FUNCTIONS
P.14 and 17)
P.14)
21
En