Preparations; Connections - Yamaha NP-S2000 Owner's Manual

This section describes preparations required before operating this unit.

Connections

Depending on the system structure you want to establish, make cable connections of the system components.
Speakers Amplifier
1
R BALANCED OUT R
This unit (NP-S2000) *U.S.A model
1 Connect this unit to your amplifier with an XLR
balanced cable, RCA stereo cable, coaxial digital
audio cable or optical cable.
y
Select one of the audio connections shown above. If your
amplifier is equipped with XLR balanced input jacks, we
recommend a balanced connection for optimum audio
performance.
2 Connect this unit to your broadband router with an
STP (shielded twisted pair) network cable (CAT-5 or
higher straight cable).
3 Connect the power cable to AC IN and then plug
into an AC outlet.

PREPARATIONS

OUTPUT
NETWORK
ANALOG OUT L BALANCED OUT L
PC
NAS
(for full system only)
DIGITAL OUT SYSTEM CONNECTOR
OPTICAL COAXIAL
* Used for product inspection service
Power cable (supplied)
■ About the spike feet
The feet of this unit include built-in spikes that can reduce
the effect of vibrations on the set. To use the spikes,
remove the magnet foot by pulling it. Also, you can adjust
the height of each foot by rotating it if this unit is unstable.
Caution
The spikes may scratch the shelf or floor. We recommend you use
a support when placing this unit on expensive furniture, etc.
Internet
WAN
Modem
LAN
Broadband
router
2
AC IN
3
To AC outlet
Spike
Magnet foot
7
En