Avoid wearing your watch while in the ー retailer or to an authorized CASIO service Example of Daily Use bath. center. Do not wear your watch while in a heated Hand washing, rain ー ...
Page 3
Leather Band ● Electrostatic charge can cause the display ● Note that CASIO Computer Co., Ltd. to go blank momentarily or cause a rainbow Allowing your watch to remain in contact ● assumes no responsibility for any effect on the display.
Watch Operation Guide 3569 General Guide Indicators Before Getting Started... ① ② This section provides an overview of the watch ① and introduces convenient ways it can be used. ② ⑤ ③ Watch Features ● ⑥ Multi Time ④ ●...
Watch Operation Guide 3569 Navigating Between Modes Graphic Display Area Viewing the Face in the Dark Each press of (C) cycles between watch Graphic display area operation is linked with The watch has a light that illuminates the face modes.
Watch Operation Guide 3569 Specifying the Illumination Duration ● Time Correction Note You can select either 1.5 seconds or three seconds as the illumination duration. Auto Light is disabled when any one of ● Use the procedures in this section to adjust the the conditions below exists.
Page 8
Watch Operation Guide 3569 Configuring the Summer Time Setting ● Use (C) to display the setting you want to Configure the date and time settings. If you are in an area that observes summer change. While the seconds are flashing, time, you can also configure a summer time ●...
Watch Operation Guide 3569 Switching between 12-hour and 24- ● Specifying Local Time Cities Multi Time hour Timekeeping (T-2, T-3, T-4) You can specify either 12-hour format or 24- Specifying Your Local Time Cities (T-2, T-3, hour format for the time display.
Watch Operation Guide 3569 Setting the World Time City Swapping Your Home City World Time Time and World Time Use the procedure in this section to select a World Time city. If you are in an area that World Time lets you look up the current time...
Watch Operation Guide 3569 To stop the alarm ● Alarm Use (B) and (D) to change the hour setting. To stop the alarm after it starts to sound when Holding down (B) or (D) scrolls through an alarm time is reached, press any button.
Watch Operation Guide 3569 Turning Off an Alarm or the Stopwatch Press (A) to turn off the displayed alarm or Hourly Time Signal the hourly time signal. Each press of (A) cycles through the The stopwatch measures elapsed time in units ●...
Watch Operation Guide 3569 Measuring a Split Time Timing the First and Second Timer Place Finishers Enter the Stopwatch Mode. The timer counts down from a start time Navigating Between Modes Enter the Stopwatch Mode. specified by you. A beeper sounds when the Navigating Between Modes end of the countdown is reached.
Watch Operation Guide 3569 Setting the Time Using the Timer Other Settings The countdown start time can be set in 1- The timer counts down time in 1/10-second second units up to 24 hours. units. This section explains other watch settings you can configure.
Watch Operation Guide 3569 Other Information Other : City Offset St. John’s -3.5 12/24-hour timekeeping, high-brightness LED light (Auto Light, afterglow, 1.5 or 3- Rio de Janeiro This section provides non-operational second illumination duration setting), Fernando de information you also need to know. Refer to...
Watch Operation Guide 3569 Troubleshooting World Time The time for a World Time City is not correct. The summer time setting (standard time/ summer time) is wrong. Setting the World Time City Alarm and Hourly Time Signal An alarm does not sound.
Need help?
Do you have a question about the 3569 and is the answer not in the manual?
Questions and answers