Avoid wearing your watch while in the ー retailer or to an authorized CASIO service Example of Daily Use bath. center. Do not wear your watch while in a heated Hand washing, rain ー ...
Page 3
Display figures may be difficult to read when ● viewed from an angle. Note that CASIO Computer Co., Ltd. assumes no responsibility for any damage or loss suffered by you or any third party arising through the use of your...
Watch Operation Guide 3547 General Guide Indicators Before Getting Started... ① ② ① ② ③ ④ ⑤ This section provides an overview of the watch and introduces convenient ways it can be used. Watch Features ● Solar Charging ⑥ ⑦...
Page 6
Watch Operation Guide 3547 Navigating Between Modes Selecting a Timekeeping Charging Mode Digital Display Format Each press of (C) cycles between watch This watch runs on power supplied from a modes. rechargeable (secondary) battery that is Each press of (B) in the Timekeeping Mode charged by a solar panel.
Page 7
Watch Operation Guide 3547 Checking the Charge Level Charge Level 5: Dead ● Charging Time Guidelines ● A display indicator shows the watch’s current The digital display will go blank if the battery The table below shows guidelines for charge level.
Watch Operation Guide 3547 Power Saving Function ● Viewing the Face in the Dark Note Leaving the watch in a dark location for about one hour between the hours of 10 p.m. and 6 The watch has a light that illuminates the face Auto Light is disabled when any one of ●...
Watch Operation Guide 3547 Specifying the Illumination Duration ● Time Correction Appropriate Signal Reception You can select either 1.5 seconds or three Location seconds as the illumination duration. A time calibration signal can be received while Your watch can receive time calibration the watch is near a window.
Watch Operation Guide 3547 Time Signal Reception Ranges Auto Time Calibration Signal Hold down (A) for at least two seconds. Receive Japan (JJY) ● This causes [On] or [OFF] to flash on the An automatic time calibration signal receive display.
Watch Operation Guide 3547 Checking the Last Time Correction Signal Reception Precautions Note Result When the watch is unable to correct its time ● Reception takes anywhere from about in accordance with a calibration signal for ● Enter the Timekeeping Mode.
Watch Operation Guide 3547 Setting the Time/Date ● Using Watch Operations to Press (C). You can use the procedure below to adjust the Adjust the Time Setting time and date settings when using the watch Use (D) to select a summer time setting.
Page 13
Watch Operation Guide 3547 Switching between 12-hour and 24- ● Keep pressing (C) until the setting you Configure the date and time settings. hour Timekeeping want to change is flashing. To reset the seconds to 00: Press (D). You can specify either 12-hour format or 24- ●...
Watch Operation Guide 3547 Setting the World Time City World Time Alarm Use the procedure in this section to select a World Time city. If you are in an area that World Time lets you look up the current time...
Watch Operation Guide 3547 Testing the alarm ● Turning the Hourly Time Use (B) and (D) to change the hour setting. In the Alarm Mode, hold down (D) to sound the Signal On or Off Holding down (B) or (D) scrolls through alarm.
Watch Operation Guide 3547 Measuring a Split Time Stopwatch Enter the Alarm Mode. Navigating Between Modes Enter the Stopwatch Mode. The stopwatch measures elapsed time in units Press (D) to scroll through alarm ([1] to [4], Navigating Between Modes of 1/100 second up to 23 hours, 59 minutes, [SNZ]) and hourly time signal ([SIG]) 59.99 seconds (24 hours).
Watch Operation Guide 3547 Timing the First and Second Setting the Time Timer Place Finishers The countdown start time can be set in 1- minute units up to 24 hours. The timer counts down from a start time Enter the Stopwatch Mode.
Watch Operation Guide 3547 Using the Timer Other Settings Press (A) to complete the setting operation. The timer counts down time in 1-second units. [MUTE] is displayed while the operation This section explains other watch settings you ● Enter the Timer Mode.
Watch Operation Guide 3547 Configuring Power Saving Other Information City Offset Function Settings YYT* St. John’s -3.5 Rio de Janeiro This section provides non-operational Fernando de Enter the Timekeeping Mode. information you also need to know. Refer to Noronha Navigating Between Modes this information as required.
Watch Operation Guide 3547 Troubleshooting The signal receive operation always Stopwatch : fails. Measuring unit: 1/100 second Measuring range: Is the watch in a location that is appropriate 23 hours, 59 minutes, 59.99 seconds (24 Signal Reception (Time for signal reception?
Page 21
Watch Operation Guide 3547 Alarm and Hourly Time Charging Signal The watch does not work even though it is exposed to light. An alarm does not sound. The watch stops operating whenever the battery goes dead. Keep the watch exposed Is the watch’s battery charged?
Need help?
Do you have a question about the 3547 and is the answer not in the manual?
Questions and answers