Do not operate the crown or buttons while ー retailer or to an authorized CASIO service Example of Daily Use your watch is submersed in water or wet. center. Hand washing, rain Avoid wearing your watch while in the ー ...
Page 3
Leather Band ● Electrostatic charge can cause the display ● Note that CASIO Computer Co., Ltd. to go blank momentarily or cause a rainbow Allowing your watch to remain in contact ● assumes no responsibility for any effect on the display.
Watch Operation Guide 3563 General Guide Indicators Before Getting Started... ① ② ① ② ③ ④ This section provides an overview of the watch and introduces convenient ways it can be used. Watch Features ● Solar Charging ● Sunlight and artificial light generate ⑤...
Watch Operation Guide 3563 Checking the Charge Level Navigating Between Modes ● Charging A display indicator shows the watch’s current Press (C) to cycle between modes. This watch runs on power supplied from a charge level. In any mode, hold down (C) for at least one rechargeable (secondary) battery that is ●...
Watch Operation Guide 3563 Viewing the Face in the Dark Note Note The watch has a light that illuminates the face When [H], [M], and [L] are all flashing Actual charging time depends on the ● ● for viewing in the dark.
Watch Operation Guide 3563 Specifying the Illumination Duration ● Time Adjustment Press (C). You can select either 1.5 seconds or three seconds as the illumination duration. Use (D) to select a summer time setting. Use the procedures in this section to adjust the [OFF] ●...
Page 9
Watch Operation Guide 3563 Switching between 12-hour and 24- ● Keep pressing (C) until the setting you Configure the date and time settings. hour Timekeeping want to change is flashing. To reset the seconds to 00: Press (D). You can specify either 12-hour format or 24- ●...
Watch Operation Guide 3563 World Time City Setting World Time Note You can specify up to five cities as your World While the setting is being configured, ● Time favorites. If you are in an area that You can view the current time in 48 cities (31...
Watch Operation Guide 3563 Configuring the Hourly Time Alarm Use (B) and (D) to change the hour setting. Signal Setting Holding down (B) or (D) scrolls through ● settings at high speed. The watch will beep when the alarm time is Enter the Alarm Mode.
Watch Operation Guide 3563 Measuring a Split Time Stopwatch Enter the Alarm Mode. Navigating Between Modes Enter the Stopwatch Mode. The stopwatch can measure elapsed time up Use (D) to display the item whose on/off Navigating Between Modes to 23 hours, 59 minutes, 59 seconds (24 setting you want to change: alarm number hours).
Watch Operation Guide 3563 Timing the First and Second Timer Press (C). Place Finishers This causes the seconds digits to flash. The timer counts down from a start time Enter the Stopwatch Mode. specified by you. A beeper sounds when the Navigating Between Modes end of the countdown is reached.
Watch Operation Guide 3563 Specifying the Day of the Enabling the Button Other Settings Week Language Operation Tone This section explains other watch settings you You can select any one of six languages for Use the procedure below to enable or disable can configure.
Watch Operation Guide 3563 Configuring Power Saving Other Information City Offset Function Settings ST. JOHN’S St. John’s -3.5 BUENOS AIRES Buenos Aires This section provides non-operational RIO DE JANEIRO Rio de Janeiro Enter the Timekeeping Mode. information you also need to know. Refer to...
Watch Operation Guide 3563 Troubleshooting Charging Timer : Measuring unit: 1 second Countdown range: 24 hours The watch does not work even Setting unit: 1 second though it is exposed to light. World Time 10-second beeper when the end of the...
Need help?
Do you have a question about the 3563 and is the answer not in the manual?
Questions and answers