Microwave - Bosch HMG736F 1 Series User Manual And Installation Instructions

en Microwave
10.2 Setting the end time
You can delay the time at which the cooking time for
the operation is due to end by up to 24 hours.
Notes
¡ To achieve good cooking results, do not delay the
time once the operation has already started.
¡ Food will spoil if you leave it in the cooking com-
partment for too long.
Requirements
¡ An operating mode and temperature or level have
been set.
¡ A cooking time is set.
Press ⁠ "End time".
1.
To set the time, press the hour display or the minute
2.
display.
a The selected value is marked in blue.
Use the setting ring to delay the time.
3.
If required, use to reset the setting value.
To confirm the set time, press
4.
Press to start the operation.
5.
a The display shows the time remaining until the oper-
ation starts. The appliance is in standby mode.
a Once the start time has been reached, the appli-
ance starts heating and the cooking time starts
counting down.
a When the time has elapsed, a signal sounds. A noti-
fication appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
6.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Changing the end time
To achieve good cooking results, only change the set
time before the operation starts and before the cooking
time starts counting down.
Press to pause the operation.
1.
Press the end time
2.
3. Use the setting ring to change the end time.
To confirm the change, press
4.
Press to start the operation.
5.
Cancelling the end time
You can delete the set end time at any time.
Press to pause the operation.
1.
Press the end time
2.
3. Use to reset the end time.

Microwave

11 Microwave
You can use the microwave to cook, heat up, bake or
defrost food very quickly.
11.1 Cookware and accessories with
microwave
To heat food evenly and avoid damaging your appli-
ance, it is important to only use the right cookware and
accessories.
Follow the cookware manufacturer's instructions.
16
on the display.
to switch the ap-
⁠ .
on the display.
⁠ .
Note: For operating modes that always require a
cooking time, the appliance resets the time at which
the cooking time ends to the next possible time.
To confirm the change, press
4.
5. Press to start the operation.
10.3 Setting the timer
The timer runs independently during the operation. You
can set the timer for up to 24 hours. The timer has its
own signal so that you can tell whether it is the timer or
a cooking time that has elapsed.
Requirement: If the appliance is switched off, press
the display first. The button lights up.
Press ⁠ .
1.
To set the timer, press the relevant time value on
2.
the display, e.g. minute display "m" or second dis-
play "s".
a The selected value is marked in blue.
Set the timer using the setting ring.
3.
To fine-tune the setting values, e.g. to set a time
‒
to the precise second, press and hold the corres-
ponding area in the setting ring for around 1 - 2
seconds. The finely tined setting values are
shown in dots.
If required, use
‒
To start the timer, press
4.
a The timer counts down.
a The timer remains visible on the display if the appli-
ance is switched off.
a When the appliance is switched on, the display
shows the settings for the current operation. The
timer is displayed in the status display.
a Once the timer has elapsed, a signal sounds. A no-
tification appears on the display confirming that the
timer has finished.
Changing the timer
You can change the timer at any time.
If the timer is running in the background, use
1.
select the timer beforehand.
Press ⁠ .
2.
Change the timer using the setting ring.
3.
Press to confirm.
4.
Cancelling the timer
You can cancel the timer at any time.
If the timer is running in the background, use
1.
select the timer beforehand.
Press ⁠ .
2.
Reset the timer using
3.
Unless otherwise specified, place the cookware and
accessory on level 2.
Microwave-safe cookware
Cookware made from heat-resistant, microwave-safe
material:
¡ Glass
¡ Glass ceramic
¡ Porcelain
¡ Temperature-resistant plastic
on the display.
to reset the setting value.
on the display.
.Reset the timer using .
to
to