Electrical Connection; Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Adjusting The Legs - Beko BUDF 700 User Manual

4- You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal. Due to
the operation of fans inside the
appliance, overall noise level is slightly
higher in comparison to non-frost free
appliances. This is quite normal and
is not a fault.
5- Front edges of the refrigerator may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.

Electrical connection

Connect your refrigerator to a
grounded socket which is being
protected by a fuse with the
appropriate capacity.
Important:
• The connection must be in
compliance with national regulations.
• The power cable plug must be easily
accessible after installation.
• Voltage and permitted fuse protection
are indicated in the "Specifications"
section.
• The specified voltage must be equal
to your mains voltage.
• Extension cables and multiway plugs
must not be used for connection.
B
A damaged power cable must be
replaced by a qualified electrician.
B
The appliance must not be operated
before it is repaired! There is danger
of electric shock!

Disposing of the packaging

The packing materials may be
dangerous for children. Keep the
packing materials out of the reach
of children or dispose them of by
classifying them in accordance
with the waste instructions. Do not
dispose them of along with the
normal household waste.
The packing of your appliance is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old appliance
without giving any harm to the
environment.
• You may consult your authorized
dealer or waste collection center
of your municipality about the
disposal of your appliance.
Before disposing of your appliance,
cut out the electric plug and, if there
are any locks on the door, make
them inoperable in order to protect
children against any danger.

Adjusting the legs

If your refrigerator is unbalanced;
You can balance your refrigerator by
turning the front legs of it as illustrated
in the figure. The corner where the
leg exists is lowered when you turn
in the direction of black arrow and
raised when you turn in the opposite
direction. Taking help from someone
to slightly lift the refrigerator will
facilitate this process.
7
EN