Subscribe to Our Youtube Channel
Related Manuals for Schacht ARRAS STAND SL2230
Summary of Contents for Schacht ARRAS STAND SL2230
- Page 1 SL2230 ARRAS STAND ssembly SHOWN WITH OPTIONAL ARRAS TRAP ARRAS LOOM SOLD SEPARATELY Find out more at schachtspindle.com Schacht Spindle Company 6101 Ben Place Boulder, CO 80301 303.442.3212 © 2023 Schacht Spindle Company, Inc. 11.23...
-
Page 2: Tools Required
1/4-20 plastic wing nuts PARTS 1/4-20 x 2-1/4" Phillips truss front legs head machine screws rear legs 1/4-20 barrel nuts treadle support 1/4-20 x 2-1/4" Phillips truss left mounting plate head machine screws right mounting plate knobs with 1-1/4" shafts fold-up supports T-nut slides 1/4-20 x 1-3/4"... -
Page 3: Assemble The Stand
ASSEMBLE THE STAND Orient the front legs (long) and rear right front leg legs (short) as shown in Figure 1, so that you have one left leg and one right 1/4-20 x 1-3/4" leg. Phillips truss head machine screw #12 SAE washer Insert a 1/4-20 x 1-3/4"... - Page 4 If you assemble the Treadle NOTE: Kit and Arras Stand at the same time, see the Treadle Kit assembly manual treadle support for attaching treadles to the treadle support. Assemble the treadles first, then proceed with this step. Place the treadle support between the rear legs, with its pins going into holes in the rear legs.
- Page 5 knobs to remove leg extension FIGURE 7: REMOVE LEG EXTENSIONS AND KNOBS FROM LOOM knob to remove FIGURE 8: REMOVE KNOBS FROM LOOM WITH BEAM KIT – 5 –...
- Page 6 Identify the right and left mounting T-nut slide. For a loom with no beam plates: the inner sides have wide kit, add a 3/8" USS washer, then insert grooves and the outer sides have the screw through the loom leg slot guides attached to them.
- Page 7 Place the loom on the stand: the side of the loom. To adjust the height stand legs fit between the guides on of the loom, loosen only these knobs, the mounting plates and the loom reposition the loom, and then tighten uprights or beam kit bases, as shown the knobs.
- Page 8 USING THE ARRAS STAND Removing the Arras Loom from the Unscrew the knobs on the Remove the Stand: Folding the Stand legs: Stand legs (attaching the mounting plastic wing nuts and screws holding plates). If you want to use the Loom on the fold-up supports to the rear legs.
Need help?
Do you have a question about the ARRAS STAND SL2230 and is the answer not in the manual?
Questions and answers