Download Print this page
Firstech RF-1WG9R-SP Quick Start Card

Firstech RF-1WG9R-SP Quick Start Card

Advertisement

Quick Links

8102REUCL000400 // REV1
QUICK START CARD
RF-1WG9R-SP
Tap the Lock Button to lock your doors and/or arm your vehicle. Hold this button for 3.5
seconds to activate panic/vehicle locater.
Tap the Unlock Button to unlock your doors and/or disarm your vehicle.
Hold this button for 2.5 seconds to pop your trunk. If not equipped, ask your Authorized
Dealer for details on how to get it.
Hold this button for 2.5 seconds to start your vehicle. Your remote's LED will blink showing
the remote start run time. Repeat and your vehicle will shut off.
Auxiliary 1: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Trunk
release button.
Auxiliary 2: Press and hold Trunk + Start Buttons for 2.5 seconds and then tap the Start
button.
Tap these two buttons at the same time to turn Valet Mode off. Turn Ignition On and
tap buttons to turn on. Hold them for 2.5 seconds to turn your FT-DAS or Shock
Sensor on or off.
Tap these two buttons at the same time to turn the horn or siren chirps on or off.
Tap these two buttons to activate Passive locking/arming. Your system will lock/arm
after 30 seconds if enabled. Hold these two buttons for 5 seconds to activate 2nd Car
Mode. Your LED will switch from amber to red. *Red LED denotes 2nd Car Mode.
2W4BLED_QuickCard.indd 1
2013/6/6 11:14:43

Advertisement

loading
Need help?

Need help?

Do you have a question about the RF-1WG9R-SP and is the answer not in the manual?

Questions and answers

Charlie Gust
February 26, 2025

HOW DO YOU PROGRAM A MODEL #1WG9R-SP REMOTE STARTER?

Summary of Contents for Firstech RF-1WG9R-SP

  • Page 1 8102REUCL000400 // REV1 QUICK START CARD RF-1WG9R-SP Tap the Lock Button to lock your doors and/or arm your vehicle. Hold this button for 3.5 seconds to activate panic/vehicle locater. Tap the Unlock Button to unlock your doors and/or disarm your vehicle.
  • Page 2 QUICK START CARD RF-1WG9R-SP START ERROR CODES PARKING LIGHT FLASHES REMOTE START ERROR 3 then 1 1: Motor running 3 then 2 2: Key in ignition on position 3: Door open 3 then 3 (manual transmission only) 3 then 4...