Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Firstech 600R
Summary of Contents for Firstech 600R
-
Page 1: User Manual
8102REUSL000200/ FT-600R V1 By Firstech LLC Version 2.0 (C-04) www.firstechonline.com www.compustar.com User Manual Applicable to the following remote(s) 600R 700R FCC ID : VA5JR260A433 Toll Free : 888-820-3690 21903 68th Ave S Kent, WA 98032... - Page 2 Thank you for purchasing a Firstech 600R / 700R system for your vehicle. In order to truly enjoy the benefits of this system, we recommend that you Read this entire manual. Please note that this manual applies to the 600R / 700R 4 Button Remote. The 600R and 700R can be used with the basic alarm, starter, or alarm Sending Commands and starter systems.
-
Page 3: Valet Mode
IMPORTANT: While in Valet mode the remote start will not activate. the circuit board. The 600R and 700R requires one A23 battery. These specialty batteries can be purchased from your local Firstech dealer or an electronics store. With the CS600-A the alarm triggers will not function however the doors will still function. -
Page 4: 1 Way Remote Button Functions
Quick Reference Quick Reference Button Duration Additional Function / Description Additional Button Duration Function / Description Programming Required Programming Required 0.5 seconds Locks doors and/or arms alarm. 0.5 seconds Yes, See Installer Ignition Controlled Door Locks AS/A System Only 3.5 seconds Panic/vehicle locater (flashes vehicle’s parking lights and sounds siren and horn). - Page 5 When in range, and a button has been pressed, the remote’s bright blue LED will illuminate and vehicle’s parking lights will flash. For example, to send a chirp twice to show it is off. remote start command from the 600R, hold down the Button for 2.5 seconds. The remote bright blue LED will come on solid and then flash.
- Page 6 General System Functions General System Functions Hold button for 2.5 seconds to release the trunk or hatch. If you are in range, the vehicle’s parking lights will flash once and/or Only available with AS/A systems. siren chirp once indicating that the trunk release command has been successfully transmitted. Hold buttons simultaneously for 2.5 seconds to turn the shock sensor on and off.
- Page 7 General System Functions Remote Coding / Programming Routine IMPORTANT: The 600R/700R remotes are preprogrammed to your system. In the event you need to program your remotes follow this simple procedure below. Only available with AS/S systems. Timer start mode is used to cool or warm the vehicle without manually starting with the key or from the remote. While engaged, timer start will activate even while the remote is out of range.
- Page 8 DAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS, COMMERCIAL LOSS, LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE that may or may not resulted from the operation of Compustar, Compustar Pro, Arctic Start, Vizion, or NuStart. NOT WITH STANDING THE ABOVE, MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE.
Need help?
Do you have a question about the 600R and is the answer not in the manual?
Questions and answers