ProScan PLT7100G User Manual page 5

Ucar Manusi
Setting up for the first time
Charging your devicer
For firsttime use, you need to charge the device for ten hours.
|
After that you can recharge the device as needed
Connect the DC-in jack to your device and plug the AC adapter into any AC outlet.
EMPS]
1. This device adopts bult-in polymer battery. Only the specified charger should be used,
2. Itis normal for the device's surface to become warm during charging or long
periods of use. All devices are factory tested before release.
3, Ifyou do not use this set for a long time, please charge/release it once
'one month to avoid deep discharge. The damage caused by battery over-consuming Is not included in the warranty.
Battery Saving
To save battery running Ife, please see below key points. With below suggestions, battery can run longer time after fully charged
each time
1. When device is not in use, press power button once to go to sleep mode.
Shut down the applications when nat in use.
Turn off WLAN when not in use
Shut off application sync selection
Reduce brightness of display