Before You Start; Interference; Out Of Range' Warning; Making And Answering Calls - Binatone DP411 User Manual

Color profile: Generic CMYK printer profile
Composite Default screen
Installation and set-up
8
Connect the base unit to the telephone line
Switch off power at the mains socket
Insert the telephone line plug into
the socket as shown
Switch mains power back on
Make sure the mains socket is
switched on if you want to use
the phone — it will not work
without electrical power

Before you start

Interference

If the sound quality gets worse as you move around
while on a call, this is probably caused by interference
between the handset and the base unit, perhaps
because you are too near to another phone or other
electrical equipment.
Move to a different position to clear the interference.
If you do not move, your call may be cut off.
Radio interference in the environment may occasionally
!
cause a short break in the link between the handset
and the base unit while you are on a call. The
handset's display will flash briefly, while the unit
automatically restores the link.
'Out of range' If you hear a warning tone during a call, and/or the
warning sound in the earpiece becomes faint or distorted, you
may be going out of range of the base unit. Move
nearer to the base unit within 20 seconds, until the
tone stops. Otherwise, your call may be cut off.
8
E:\Binatone2003\S_2300\s2300_UK_draft02.vp
27 November 2003 19:50:00
Use the plug to
raise the shutter
before pushing
it into the socket
NOTE: the charger pod does not have
a connection to the telephone line.

Making and answering calls

When you make or answer a call, the display shows the
call's duration in minutes and seconds.
The handset's When you press the SPEAKERPHONE button
speakerphone you can listen without holding the handset to
your ear.
You can press the SPEAKERPHONE button any
time during a call to switch the speakerphone
on and off; but you must press the PHONE
button to end a call.
1
To make a Key in the telephone number
call
If you make a mistake, press the MUTE/DEL
button to clear digits one by one from the
display. To clear all digits, press and hold the
MUTE/DEL button.
2 Press the PHONE or SPEAKERPHONE button
(You can dial the number after you press the
PHONE button if you prefer, but you won't be
able to correct any mistakes if you do it that
way.)
To answer a When the handset rings:
call
◗
Press the PHONE or SPEAKERPHONE button
◗
To end a call Press the PHONE button so that the
symbol disappears from the display
Binatone Help Line: 01325 304 473 9