Hobby Boss German 12.8cm FLAK 40 Manual

1:35 Scale ITEM N0.:84545
- - ' .,, ¥i:--:,;,
~
PLEASE READ BEFORE OPERATION !
*
Tools recommended as below: (Not included)
Adhesives; Paints ; Side Cutters; Sharp Edged Pliers ; Modeling Knife ; Modeling
File ; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
*
Make sure to read this instruction listed below before assembling .
*
The kit contains the small parts , they can be dangerous if swallowed by mistake,
so keep them away from reach of children .
*
Cut the all parts off carefully and remove the waste parts into the garbage can .
*
More caution and care should be needed for cutting and handling the photo
etched parts.
*
Make attention that some parts should be attached the decal when assembled .
*
During assembling , please tear up and throw away the plastic bags , or may cause
the dangerous if wearing over head by children's mistake.
*
When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes,face and clothes .
*
Adult supervised when assembled by children under 14 years old.
8
m
Lffl
~ ~ ~
*~wHwfHIHf#J~:
*
t!UHUll (t-JiH!'i.I~ (it~~ l :
~m•~•*·
~m•~~••* □ Dn,
*•~
n~.
~n.
tl'Hlt, ~ .
Dn ,
$J.::i' i i , ~J/tit .~fsJ•~'f&~o
*
Jll* □ Dn!l!n~JJ,,e,,tJJrPli'~ma~fnot!ll~J~~f*,
,F~w;~Jj\~f*o
*
tJJilxt!JltrJ~a10¥.HltJi1'.llf-~J1:.frJJll:lttJfjj-¥mo
*
Jlltl~~JJ JJ,,e,,tf.;p:JiJr~~fi,&ilii(t-Ji:Ut~ □ o
*
Jll~:§!:(t-Js!il;/J•~'fR*:fS-g-t!Jl~J~~fHo~~$ili ' tJJ,ttd:1
:!I , 's'JiltFifliHBfi>Jiif.J~fH~:fSf1o
*
i1'.llf-::lt~~fi,&iiii'ilUE~IRa1f511HS...t*!ilStito
*
:Mfta-t@fil~iJJJLm~fil~*&aii&~.
ii~JJ,fiim~
ii'osl~'.llf-9l'o
C
r;
0
5§\;/Jijl(
!lc:m
Weight
tHL
Make hole
tJ]~
m a
Option
,fi#iJt::Z7)<
M~
Decal
~ tlJJ
Bend
71':~
Install it first
Cyanoacrylate glue Cut/Remove No cement
The method to apply the decals
1.Cut off the decal from the decal paper and put it into the warm water 40 C for 10
seconds.
2.Take the decal from the water and put it on a piece of clean cloth .
3.Remove the decal slowly from the paper to the targeted location by a wet finger.
4.Use a piece of dry and soft cloth to press it gently on the decal until it getting dry
and no bubble existing .
84545
7.1<
JilMK tt:l ft ffl 71
ii :
- . te!ti:J*(t-JfPi-F;J.J-.*!ilMIUDr,
!NJ\40 -C
~t,(t]
iNA*
'P
i:lH O
f' . ll
o =·
Afif§-:i%fP1-t!Ntt'f~(tJ:i'ii...to
.:::. .1i!:...tfPi-F;tit*-&, -¥1'~il*~~fpi-F;fti~~~ (t-Jfft.' l !i'o
11!1 •
Jll!fj:'f:(jj~J:Hpi-F;][~*T, ~)§)i/J~o