Hobby Boss Tornado IDS Quick Start Manual

The method to apply the decals
80353
1/48 Scale
ITEM N0.:80353
Tornado IDS
" SR " IDSSHiftJtSffl,
s
no cement
cut I remove
W
0
weight
SB®
make hole
an
decal
B
Using CA super glue option
repair
bend
-.fflffi£MEP#AU<B ' ft±WT, &A40C^aM
Szk't ' iSW.
H.£±Ep®Rffi, ¥#«*fcEPEi&SJifiSm«.
SfflIH®*, KBW, ZJtt,
&7L ilFFW, &, UZI, Wfi,
* ratt^RWE^ijawKikwasij^jg.
* tfISH
it,
PLEASE READ BEFORE OPERATION!
* Tools recommended as below: (Not included)
Adhesives; Paints; Side Cutters; Sharp Edged Pliers; Modeling Knife; Modeling
File; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this instruction listed below before assembling.
* The kit contains the small parts, they can be dangerous if swallowed by mistake,
so keep them away from reach of children.
* Cut the all parts off carefully and remove the waste parts into the garbage can.
* More caution and care should be needed for cutting and handling the photo
etched parts.
* Make attention that some parts should be attached the decal when assembled.
* During assembling, please tear up and throw away the plastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes,face and clothes.
* Adult supervised when assembled by children under 14 years old.
1 .Cut off the decal from the decal paper and put it into the warm water 40 C for 10
seconds.
2. Take the decal from the water and put it on a piece of clean cloth.
3. Remove the decal slowly from the paper to the targeted location by a wet finger.
4. Use a piece of dry and soft cloth to press it gently on the decal until it getting dry
and no bubble existing.
' J
■ «