Hobby Boss P-61A Manual

1
87261
Item NO.:87261 1:72 Scale
US P-61A Black Willow
P-61A 7'7 7
HBP-61A " SB
no cement
cut / remov
Wit
cyanoacrylate glue make hole
&?L
decal
m
weight
SES
option
£7?
repair
«ll'
install it first
bend
PLEASE READ BEFORE OPERATION!
* Tools recommended as below: (Not included)
Adhesives; Paints; Side Cutters; Sharp Edged Pliers; Modeling Knife; Modeling
File; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this instruction listed below before assembling.
* The kit contains the small parts, they can be dangerous if swallowed by mistake,
so keep them away from reach of children.
* Cut the all parts off carefully and remove the waste parts into the garbage can.
* More caution and care should be needed for cutting and handling the photo
etched parts.
* Make attention that some parts should be attached the decal when assembled.
* During assembling, please tear up and throw away the plastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes,face and clothes.
* Adult supervised when assembled by children under 14 years old.
^SEmWWlW;
Tknwzj, KOW, 77R.
«77, ijmtt.
-. £ M Ep T, A40 C
Szk+iSW.
-. ^ftEPOtST
E.<t±EP£4ftfe, ¥7SBTK^EP7t^SJiS^a<)aa o
The method to apply the decals
1 .Cut off the decal from the decal paper and put it into
the warm water 40 C for 10 seconds.
2. Take the decal from the water and put it on a piece
of clean cloth.
3. Remove the decal slowly from the paper to the
targeted location by a wet finger.
4. Use a piece of dry and soft cloth to press it gently on
the decal until it getting dry and no bubble existing.
I.