Hobby Boss P-61C Black Widow Manual

fl
P-61C Bli
P-
61
C K
7
ac
t
kWidow
mip-6ic"i
PLEASE READ BEFORE OPERATION!
* Tools recommended as below: (Not included)
Adhesives; Paints; Side Cutters; Sharp Edged Pliers; Modeling Knife; Modeling
File; Nippers; Drill; Scissors; Sand Paper; Soft Cloth; Cyanoacrylate Glue.
* Make sure to read this Instruction listed below before assembling.
* The kit contains the small parts, they can be dangerous if swallowed by mistake,
so keep them away from reach of children.
* Cut the all parts off carefully and remove the waste parts into the garbage can.
* More caution and care should be needed for cutting and handling the photo
etched parts.
* Make attention that some parts should be attached the decal when assembled.
* Düring assembling, please tear up and throw away the plastic bags, or may cause
the dangerous if wearing over head by children's mistake.
* When using the adhesives and paints, please do not use them in the closed room
or near the fire, also must be very careful to protect your eyes,face and clothes.
* Adult supervised when assembled by children under 14 years old.
ifco, »rn $S, MT], tt*. «MK.WiiHjmft*.
* tnaa
The method to apply the decals
1 .Cut off the decal from the decal paper and put it into
the warm water 40 " C for 10 seconds.
2. Take the decal from the water and put it on a piece
of clean cloth.
3. Remove the decal slowly from the paper to the
targeted location by a wet fingen
4. Use a piece of dry and soft cloth to press it gently on
the decal until it getting dry and no bubble existing.
mTk+iSlO#.
= .*±
ep
8
ä
«,
V
cyanoacrylate glue
weight
I5S
make hole
cut
/ remov
Option
IÄ7L SS
no cement decal
bend repair
81732 1