Operation; Charging The Battery Pack - Toro Flex-Force Power System 60V MAX 88901 Manual

Operation

Charging the Battery Pack

Important:
The battery pack is not fully charged when you purchase
it. Before using the tool for the first time, place the battery pack in
the charger and charge it until the LED display indicates the battery
pack is fully charged. Read all safety precautions.
Important:
Charge the battery pack only in temperatures that are
within the appropriate range; refer to
Note:
At any time, press the battery-charge-indicator button on the
battery pack to display the current charge (LED indicators).
1. Ensure that the vents on the battery and charger are clear of any
dust and debris.
2. Line up the cavity in the battery pack
the charger.
3. Slide the battery pack into the charger until it is fully seated
4. To remove the battery pack, slide the battery backward out of the
charger.
5. Refer to the following table to interpret the LED indicator light on
the battery charger.
Indicator
light
Off
Green
blinking
Green
Red
Red blinking
*Refer to Troubleshooting (page 15)
Important:
The battery can be left on the charger for short periods
between uses.
If the battery will not be used for longer periods, remove the battery
from the charger; refer to
Indicates
No battery pack inserted
Battery pack is charging
Battery pack is charged
Battery pack and/or battery charger is over or under the appropriate
temperature range
Battery pack charging fault*
Storage (page
Specifications (page
(Figure
for more information.
14).
12
11).
4) with the tongue on
(Figure 4).