SNEED Coding Solutions SNEED-PACK User Manual page 3

Troubleshooting
(1) Speed Control does not light up:
Check the source of the power supply and the fuse inside the transformer. The fuse shall
be 10A/220V. And check whether the power supply button is pressed down.
(2) Abrasion of guide belt and paging belt:
The machine shall be shut down when no product is put on, thus to reduce abrasion. For
normal abrasion, please change the guide belt and paging belt: screw off the bolts to take
down the paging panel, and change the guide belt or paging belt.
(3) Conveying belt deviation:
It can be adjusted by adjusting the tension bolt at the end of the conveying belt.
(4) For paging problems:
Please refer to the adjusting steps in the Instruction about Operation
(5) Conveying belt motor doesn't rotate:
a. Check whether the Speed Control is set as zero or not; check whether the
Start/Stop button is pressed down or not; whether the guide belt, paging
belt, or conveying belt is blocked by product or damage, or by deviation of
products.
b. All bearings of rotating parts shall be added with lubrication oil periodically.
www.sneedcoding.com | 833-926-3464 x2 | support@sneedcoding.com