II. Instruction about operation
*Please read through this instruction manual before using this machine or connecting the
power supply.
First time operation:
1. Connect the power cable to a single-phase power supply. It is required to have a well
grounded outlet.
2. Turn on the power supply. The panel should light up.
3. Adjustment:
Adjust the paging width by adjusting the space between the left and the right guide pieces
to fit the width of the product for paging. The space should be 0.5-1mm wider than the
product. The center of the product should be aligned to the center of the guide belt. Then
tighten the bolts on the front and the back guide pieces.
4. Operation:
Put the product in to check for operation. The product should not adhere, or stick, to the
guide rails or support plates. Make sure the product slope is inclined backwards and
pushes it into the baffle plate position.
5. Paging pressure adjustment:
In order to make the products be output piece by piece successfully without overlapping or
blocking, the interval and pressure between the pressing separator and the paging belt
needs to be adjusted. If the products are overlapping or blocking the output due to
differences in material and specification, it needs to be readjusted. The screw on the
pressing roller of the green separator should be adjusted to make it able to increase or
decrease the pressure on the pressing roller to solve the problem of overlapped paging or
output blocki. Overlapped paging needs to increase the pressure of the adjusting screw on
the pressing roller. Output blocking needs to decrease the pressure of the left and right
roller screws on the pressing roller.
6. Run/Stop:
Connect to the power supply and press the green button. The Speed Control will turn on.
Press the red Start/Stop button to turn on the belt. Rotate the black dial of the Speed
Control clockwise to adjust the speed. If you need to pause paging, or no product is put in,
please press the red Start/Stop switch to shut down the machine. In order to avoid damage
from long term friction between pressing separator and the paging belt put materials in
continuously while paging or shut down the machine if no product is present.
7. Speed adjustment:
In order to perform paging for the products successfully, the Speed Control can be adjusted
to regulate the speed of the whole machine.The speed can be accelerated or decelerated
by rotating the black knob on the Speed Control. The changes will be reflected in the
readout on the Speed Control.
8. Shutdown:
At the time of shutdown, please press the red Start/Stop button first, and then press the
green power supply button, and finally pull out the plug.
www.sneedcoding.com
| 833-926-3464 x2
|
support@sneedcoding.com
Need help?
Do you have a question about the SNEED-PACK and is the answer not in the manual?