Advertisement
Advertisement
Table of Contents
Related Manuals for Bestway 58748
Summary of Contents for Bestway 58748
- Page 1 58748 OWNER’S MANUAL bestwaycorp.com/support Visit the Bestway YouTube channel...
-
Page 2: Important Safety Instructions
30 mA. Extension cords can’t be used. If instruction is missed, please contact with Bestway or search it in website: www.bestwaycorp.com. CAUTION: Ensure all installation or service work is only carried out by licensed personnel. - Page 3 of ignition is minimised. For repair to the refrigerating system, the following shall be completed prior to conducting work on the system. Work procedure Work shall be undertaken under a controlled procedure so as to minimise the risk of a flammable gas or vapour being present while the work is being performed.
- Page 4 Cabling Check that cabling will not be subject to wear, corrosion, excessive pressure, vibration, sharp edges or any other adverse environmental effects. The check shall also take into account the effects of aging or continual vibration from sources such as compressors or fans. Detection of flammable refrigerants Under no circumstances shall potential sources of ignition be used in the searching for or detection of refrigerant leaks.
- Page 5 e) If a vacuum is not possible, make a manifold so that refrigerant can be removed from various parts of the system. f ) Make sure that cylinder is situated on the scales before recovery takes place. g) Start the recovery machine and operate in accordance with instructions. h) Do not overfill cylinders (no more than 80 % volume liquid charge).
-
Page 6: Installation
INSTALLATION For the installation, follow the instructions in this manual. Drawings in the assembly section are for illustration purposes only and may not reflect actual product. Not to scale. RECOMMENDATIONS DURING THE INSTALLATION - In order to heat the water in the pool, the Filter Pump must be running to circulate the water through the Pool Heater. It will not start up if the water is not circulating. - Page 7 The water temperature as tested by an external thermometer may vary from the temperature as displayed on the panel by as much as approximately 2°C(35.6°F). The Pool Heater has been tested under the limited condition with ambient temp. 43°C (Dry bulb) and 26°C (Wet bulb) Model No. 58748 * General data Water Flow Volume (m³/h) ≥2.0 Advised pool size m³...
-
Page 8: Maintenance
MAINTENANCE CAUTION: You must ensure the Pool Heater is unplugged before beginning the maintenance to avoid risk of injury or death. - Please check the filtration system regularly. Sand and Filter cartridge must be kept clean and the air must be eliminated to avoid low water flow, which could damage the Pool Heater and reduce the performance. - Page 9 CLEANING Improper cleaning can result in damage to the device. Cleaning the heat pump • Do cut off the power supply before the cleaning process • Do not use any aggressive cleaning agents • Do not use any sharp or metal objects such as knives, hard putty knives or the like •...
- Page 10 ×1 ×2 ×3 ×1 ×1 ×1...
- Page 11 Φ8...
- Page 12 Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia Tel: Australia: (+61) 2 9037 1388; New Zealand: 0800 142 101 Distributed in United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL Exported by/Exporté par/Exportado por/Exportiert von/Esportato da Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited...
Need help?
Do you have a question about the 58748 and is the answer not in the manual?
Questions and answers