OG-HDM2.0-1x4 WHAT’S IN THE BOX OG-DA-4HD-II-SET-1 • 1 x OG-DA-4HD-II-MB • 1 x OG-DA-4HD-II-RM OG-SDI-EM-12g-SET-2 • 2 x OG-DA-4HD-II-MB • 1 x OG-DA-4HD-II-RM2 Key Features OGX/3.0 card-based form factor. – Dashboard control enabled. – 1 x 4 triple rate reclocking SDI distribution amplifier with passive loop out –...
Getting Started The Dashboard software is design to allow you to quickly access the feature sets of openGear form factor cards on a simple User Interface. This section will help you get up and running as quickly as possible. Running Dashboard...
OG-DA-4HD-II Now you can run the Dashboard by double clicking on the Dashboard icon. OG-DA-4HD-II Dashboard GUI OG-DA-4HD-II is a very straight forward plug and play card. The Dashboard interfaces are as follows, 5.3.1 Signal Status APANTAC LLC, 10200 SW ALLEN BLVD, BEAVERTON, OR 97005...
OG-DA-4HD-II Appendex A COPYRIGHT, TRADEMARK, and REGISTRATION All rights reserved by APANTAC LCC, Beaverton, Oregon, USA. No part of this document may be reproduced in any form or by any means without written permission from the product manufacturer. Changes are periodically made to the information in this document.
Page 7
OG-DA-4HD-II (c) if after a reasonable time, is unable to correct the defect or provide a replacement Product in good working order, then the purchaser shall be entitled to recover damages subject to the limitation of liability set forth below.
Need help?
Do you have a question about the OG-DA-4HD-II and is the answer not in the manual?
Questions and answers