Sewell BlastIR Wireless Manual

BlastIR Wireless IR Receiver
BlastIR Wireless IR Emitter
Dual IR Emitter Cable
IR Receiver Cable
(2) Airstick™ Microsuction Tape
(2) 3m Adhesive
(2) 5V .5A Power Supply
(2) USB to DC Cable
(2) Rubber Magnet Feet
Can help improve
responsiveness
is clean before attaching the adhesive
attaching the adhesive
Status LED
Optional IR Emitter
Cable Port
- The BlastIR Wireless Pro transmission range can be reduced
by walls or other objects between the receiver and emitter as
well as by other wireless signals in the same area. If you are having
trouble with the emitter receiving the signal we recommend testing
it with the receiver and emitter in the same room in order to verify
that nothing is interfering with the signal.
- If the emitter or receiver seems to be cutting in and out, then the
power connector may not be properly seated. We recommend
reseating in the power connector. Keeping the modules in a place
where there is minimal vibration or other movement will help
prevent the power connectors from coming loose.
- Make sure that they receiver and emitter are set to the same
desired channel before use. If they are on a different channel, then
the emitter will not recognize the signal from the receiver.
Please ensure that the surface is clean before
Built-in IR Emitter
Troubleshooting
The IR Emitters transmit from
from the adhesive side of the
head and should be adhered
directly over the location
where your device receives
its IR signal. (Location Varies)
Please ensure that the surface
Built-in IR Receiver
Optional IR Receiver
Cable Port
10