Advertisement
PLAYBACK (RELAY PLAYBACK)
RELAY PLAYBACK
When relay playback mode is selected, continuous playback can be
performed.
When the tape in the first deck reaches its end and
stops, the other deck will automatically begin playback.
1. Load prerecorded tapes in DECK ! and DECK ]L
2. Select the Dolby NR mode with the DOLBY NR button.
•
Always set the switch to the same positions that were used
for recording,
3. Select the I c-._ ) reverse mode with the REV MODE
button (see page 9),
4, Set the stereo amplifier for tape playback,
E. Press the playback 11_or <) button of the deck that
will start to play first.
• When the tape in one deck ends, the other deck automatically
begins playback.
• To cancel relay playback, press the stop (11)button.
To improve high frequency sound during playback in tapes
_dh peor recordings_Except for U.S. model of CT-W606DR)
Pressthe FLEXbuttonand playbackthe tape.
NOTES:
•
Relay playback can begin from either DECK I or DECK II.
•
The tape in the idle deck can be replaced during relay playback
mode, allowing many tapes to be played back continuously.
This
is a convenient
feature for parties, background
music, etc.
•
When this mode is selected,
if the deck encounters
an unre-
corded portion of tape more than 15 seconds in length, it will fast
forward the tape until it encounters another recorded portion, and
resume playback from that point.
I
MUSIC SEARCH
(Skipping forward or backward to playback a desired selection)
The music search function
detects
blanks {longer than 4 seconds)
between
selections, advances the tape in the forward or reverse di-
rection to find the beginning of the desired se[ection and automati-
cally starts playback.
It can find a selection located up to 15 selections before or after the
present position.
During
forward
playback
When you wish to locate a future song, press the IH_ button as
many times as the number of songs to be skipped. When you wish
to listen to the song currently being played from the beginning, press
the <1< button once. To return to a previously played song, press the
<P< button as many times as the number of songs to be skipped,
plus one.
During
reverse
playback
When you wish to locate a future song, press the -<<1button
as
many times as the number of songs to be skipped. VVhen you wish
to listen to the song currently being played from the beginning, press
the mH_button once. To return to a previously played song, press the
button as many times as the number of songs to be skipped,
plus one.
From the stop mode
Press the playback {1_-or <) button to set the playback mode, then
press the <P_ or _
button to perform music search as mentioned
above.
•
If the button is pressed more times than the number of selection
To stop playback
temporarily
)DECK 11 only)
Press the pause (11)button.
•
To resume playback, either press the pause (11)button again, or
press the playback (1_ or <1)button.
To stop playback
Pressthe stop (11) b uttonof the operating deck.
PLAYBACK SEQUENCE WITH REV MODE BUTrON SE'rFING
The playback sequence depends on the setting of the REV MODE
button and on which playback (Ib or <1) button is pressed first. The
playback sequence
for each possible selection is shown below.
*2 In the repeat ( _
) mode, relay playback always begins from the
forward direction.
I l>
: DECK I forward playback
I <1 ; DECK I reverse playback
Ill>
: DECK |[ forward playback
II <a : DECK 11reverse playback
o=
: Auto-reverse
function
---
: Relay
REV
Starting
Another
MODE
playback
deck
button
button
mode
Playback sequense
DECK l _
"2
[C>ool<3-.*ll_>ooll<_-,.l_>_]_,..
15 times relay (32 sides playback)
DECK 1.41
*2
l<Pblll>ooll<3-÷ll>ool<3-_[D...
15 times relay (31 sides playback)
*2
llt>**ll<--,.It>**l.<-.,.l lt>**II <...
15 times relay (32 sidesplayback)
"2
ll<--,.It>**l.o-,.IIt>**ll <-.,.It> ...
15 times relay (31 aideaplayback)
12
<RRB1176>
En
recorded on the tape, forward search will continue on the oppo-
site side, but reverse search will stop at the tape end.
NOTES:
In the following circumstances, the music search function may be
unable to properly detect blanks between selections; this is not,
however, a sign of a malfunction with the unit,
•
When using a tape with blanks between selections less than 4
seconds long.
•
14/hen listening to tapes with long Iowqevel intervals, like classical
music, or with sound breaks several seconds long within selec-
tions.
•
When listening to recorded conferences
or talk shows, where
sound is intermittent.
•
When using tapes with noise in the blanks between
selections.
How Selections
are counted
When starting the music search operation from the middle of a se-
lection and specifying "1 st previous selection," playback will return
to the beginning of the present selection, To return to selections
further back, count one extra selection.
Search (4<)
_1_
3rd selection
1st selection
(2 selections
(present
before) I
selection)
1
Playback11_1 _
Presentposit.3n
(next
selection)
Search(l_l_)
2ndselection
1st selection
3rd selection
Hide quick links:
Advertisement
