Connecting The Digital Audio Input Terminal; Remote Control Connection - Marantz SA-15S2 User Manual

ADVANCED CONNECTIONS
CONNECTING THE DIGITAL AUDIO
INPUT TERMINAL
When connected to devices equipped with digital outputs,
such as CD transports or MD recorders, the unit can be used
as a D/A converter.
Note:
This unit can input linear PCM signals with sampling
frequencies of 32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz, and
96kHz.
Please do not input signals other than linear PCM signals (such
as CD-ROM, Dolby Digital, DTS, or AAC signals). Signals
other than linear PCM may generate noise and damage the
speakers.
IN OUT
Optical digital
connecting cable
(available on market)
:
ANALOG IN/OUT ANALOG IN/OUT
L
R
MD MD MD MD COMMON COMMON CD CD
INPUT INPUT OUTPUT OUTPUT
CD recorder, MD deck, AV amplifier, etc.
Signal flow
DIGITAL IN/OUT DIGITAL IN/OUT
OPTICAL OPTICAL
MD MD MD/CD MD/CD
INPUT OUTPUT INPUT OUTPUT

REMOTE CONTROL CONNECTION

Connecting this player to additional Marantz audio equipment
using the supplied remote control cable enables remote control
of the connected equipment as a single audio system.
• When connecting equipment incorporating a remote sensor,
connect the "remote control out" connector of the equipment
to the "remote control in" jack of the CD player.
When doing this, set this player's switch to "EXTERNAL."
This will stop its remote control IR receiver from operating
and the player can now be controlled via the remote control
IR receiver of the attached equipment.
IN OUT
Remote connector cable
(supplied)
:
Signal flow
Amplifier
ENGLISH
SA-15S2
Set to "EXTERNAL."
15