Setting Time; Storing Location; Requesting Location - Harman Kardon TRAFFIC PRO-R Operation Manual

•
The unit display can be set from meters to yards.
•
Announcement of the estimated time of arrival can
be turned on or off.

Setting time

In order to achieve correct navigation on routes with
time-sensitive guidance and to calculate the estimated
time of arrival, it is necessary to set the GMT time
transmitted from satellites to the current time zone.
Set and confirm in the System Settings menu.
. !PL
Use the multifunction key to change the time
display from the 24-hour to the 12-hour display.
. !PL
Use the multifunction keys
26
4. Using Navigation
time is changed in half-hour intervals.
Press the right control knob
to apply the time setting.
The program jumps back to the System Settings
menu.
Note:
The calculated time of arrival is based on the time
zone where the trip originated

Storing location

Set and confirm
Settings menu.
or and the
The display shows the current coordinates (degrees of
longitude and latitude) for the position.
or multifunction key Re-confirm by pressing the right control knob
!
Enter the name of the position.
Press the right control knob
onds to confirm the name entered. To confirm, you
may also mark the small check mark
press the right control knob
The destination memory is automatically requested
(see page 23).
Select the desired position in the destination memory
with the right control knob
in the System

Requesting location

Request destination memory (see page 23) and select
the destination using the right control knob
If the position is outside a digitized area, the driver is
guided along the digitized route nearest to the destina-
tion. You will hear the announcement "Your destina-
tion is nearby." Follow the direction arrows to reach
the destination.
.
H
for more than 2 sec-
and briefly
.
and press to confirm.
.