Summary of Contents for MasterForce FLEXPOWER 252-8043
Page 1
DUAL PORT CHARGER 252-8043 OPERATOR’S MANUAL CAUTION: To Reduce The Risk Of Injury, User Must Read And Understand Operator’s Manual. Save These In- structions For Future Reference. For questions / comments, technical assistance or repair parts – Please Call Toll Free: 1-866-917-4374. (M-F 8:30am-5:00pm Est.)
SAFETY SYMBOLS Some of these following symbols may be used on this tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and more safely. Symbol Designation / Explanation Name Volts Voltage...
SAFETY INSTRUCTIONS The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The symbol warnings do not, by themselves, eliminate any danger. The instructions and warn- ings they give are no substitutes for proper accident prevention measures.
Page 5
SAFETY INSTRUCTIONS 1. This device complies with Part 15 of the WARNING: Read all safety FCC Rules. Operation is subject to the warnings and instructions! following two conditions: Failure follow warnings 1) This device may not cause harmful instructions may result in electric shock, fire interference.
Page 6
SAFETY INSTRUCTIONS CAUTION: DANGER: To reduce risk of injury, People with electronic charge only Masterforce Flexpower devices, such as pacemakers, should ® ® 20V Li-Ion rechargeable batteries listed consult their physician(s) before using this product. Operation of electrical equipment below. Other types of batteries may burst, in close proximity to a heart pacemaker causing personal injury and damage.
OVERVIEW Charging Bay 1 Red LED Charging Bay 2 Green LED Air Vents SPECIFICATIONS Charger Input 120 V~, 60 Hz, 2x150 W 25 minutes 20V 2.0Ah Li-Ion (252-8031) 35 minutes 20V 2.5Ah Li-Ion (252-8030, 252-8003) 45 minutes 20V 4.0Ah Li-Ion (252-8034) Charging Time for 55 minutes 20V 4.0Ah Li-Ion (252-8013)
ASSEMBLY PACKING LIST WARNING: If any part is broken or missing, do not attempt to plug in the - Dual port charger power cord until the broken or missing part - Operator’s manual. is replaced. Failure to do so could result in possible serious injury.
OPERATION CHARGING THE BATTERY PACK charger. 2. Connect the charger to a power supply. (FIG. 1) LED lights on the charger will flash once, indicating that the charger’s self- FIG. 1 inspection is completed. 3. Attach the battery pack to the charger by aligning the raised ribs of the battery Attach pack with the slots in the charger.
Page 10
OPERATION CHARGING A HOT BATTERY FULL BATTERY PACK After the battery is fully charged, the green LED light on the charger will be on and the If the battery pack is above the normal red LED light will be off; the green LED lights temperature range, the red LED light will on the battery will shine for approximately illuminate and the green LED light will be...
MAINTENANCE WARNING: WARNING: To avoid serious If the power cord is personal injury, always disconnect the plug damaged, it must be replaced by a specially from the power source when cleaning or prepared cord available through the service performing any maintenance. Contact a organization.
Need help?
Do you have a question about the FLEXPOWER 252-8043 and is the answer not in the manual?
Questions and answers