Timer Operation; Test Operation - Haier HSU-24LEA03 Operation Manual

Operation
HEALTH Operation
(This function is unavailable on some models.)
HEALTH ON/OFF
FAN
The anion generator
anion effectively balance the
generate a lot of
quantity of position and anion in
also to kill bacteria and speed up the dust sediment
in the room and finally clean the air in the room.
Healthy Negative ions

TIMER Operation

Set Clock correctly before starting Timer operation
You can let unit start or stop automatically a following times:
Before you wake up in the morning, or get back from outside
or after you fall asleep at night.
TIMER
CLOCK
SET
SLEEP
(3) TIMER ON-OFF
TIMER TIMER
CLOCK CLOCK
SET
SET SLEEP SLEEP
To cancel TIMER mode
Just press TIMER button several times untilTIMER mode disappears.
3
in the airconditioner can
the air and
TIMER ON
(1)
TIMER
TIMER
CLOCK
CLOCK
SET SLEEP SET
(2) TIMER OFF
TIMER
TIMER
CLOCK
CLOCK
SET
SLEEP SET
TIMER
TIMER
CLOCK
CLOCK
SET SLEEP SET
POWER/SOFT Operation
(1) POWER Operation
POWER/SOFT
TIMER
CLOCK
SET SLEEP
(2) SOFT Operation
POWER/SOFT
TIMER
CLOCK
SET SLEEP
To cancel SOFT operation
Press POWER/SOFT button again ,POWER/SOFT disappears.
Emergency operation and test operation
Emergency Operation:
Use this operation only when the remote controller
is defective or lost.
When the emergency operation switch is
pressed,the" Pi "sound is heard once, which means
the start of this operation.
In this operation, the system automatically selects
the operation modes,cooling or fan or heat,according
to the room temperature.
Room
temperature
SLEEP
ABOVE 23 C
O
BELOW 23 C
O
(Cooling only uint）
Room temperature
BELOW 23
It is not possible to operate in dry mode.
SLEEP

Test operation:

Test operation switch is the same as emergency switch.
Use this switch in the test operation when the room
temperature is below 16
normal operation.
Continue to press the test operation
switch for more than 5 seconds. After
SLEEP
you hear the "Pi" sound twice,release
your finger from the switch: the cooling
operation starts with the air flow speed "Hi".
(This function is unavailable on some models.)
When you need rapid heating or cooling,
you can use this function.
In COOL mode, fan speed automatically
takes high speed of AUTO fan mode.
In HEAT mode, fan speed automatically
takes medial speed of AUTO fan mode.
To cancel POWER operation
Press POWER/SOFT button twice ,POWER/SOFT disappears.
You can use this function when silence
is needed for rest or reading.
In SOFT operation mode, fan speed
automatically takes low speed of AUTO fan mode.
Timer
Operation Designated
Air flow
mode
mode temperature
NO
COOLING 26 C
AUTOMATIC
O
HEAT AUTOMATIC
23 C NO
O
Operation Designated
mode temperature
C FAN
26 C
O O
o
C, do not use it in the
Pi
Timer
Air flow
mode
NO
AUTOMATIC
Pi Pi