Table of Contents
Advertisement
Operation
Fan speed display
Remote controller
When the backlight source is lighting, the source color displays corresponding to the table
function columns.When two functions or more are working, the backlight source colors display
based on the priority in sequence 2,1.
Test operation
Test operation switch is the same as emergency switch.
Use this switch in the test operation when the room temperature
is below 16
C, do not use it in the normal operation.
O
Keep pressing the "Mode" and the "Temp-" at the same
time for more than 5 seconds. After you hear the "Pi" sound
twice, release your fingers from the buttons: the cooling operation starts with the air flow
speed "Hi".
Unit stop (cancel the Test operation:)
press the ON/OFF button once, then you will hear "Pi" sound and the unit will operate as
what the remote controller shows.
When you connect the power supply, all the signs of function will be displayed for 5
senconds. Then the room temperature will be shown on the display board.
When the buttons on both panel and remote controller are pressed, you will hear the sound
from the unit
TEMP
4
3
2
1
2
Control panel:
AUTO: zones1-4 circularly light
LO: zones 1-2 normally light
Display
1.The control sepuence of back light on the panel
Press Point Light Button on the remote controller each time,
the LCD display will change in order as follows:
Back light source ON
Beeper no sound
2.About the control of the backlight sounce color on the panel
Function
Standard color Priority
AUTO
White
COOL
Blue
FAN
Brick red
Remote controller:
When adjusting FAN speed during system
operation, every time the FAN button is
pressed, the fan speed changes as follows:
3
4
AUTO
MED: zones 1-3 normally light
HI: zones 1-4 all light
Back light source ON
Beeper sounds
Function
1
DRY
1
HEALTH
1
18
LO
MED
Back light source OFF
Beeper sounds
Standard color
Priority
Light blue
1
Green
2
MODE
ON/OFF
FAN
TEMP +
TEMP -
HI
Advertisement
Table of Contents
