Installation Instructions; Unpack The Air Conditioner; Wall Installation - Haier ESA415J-W Use And Care Manual

Unpack the Air Conditioner

Remove Packaging Materials
■ Remove and dispose of/recycle packaging materials. Remove
tape and glue residue from surfaces before turning on the air
conditioner. Rub a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
■ Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your air conditioner.
■ Handle the air conditioner gently.

Wall Installation

1, Using wood, 1"or more in thickness, build a wooden frame to
fit the casing/cabinet dimensions of the unit which you have
purchased.
2, Measure the outside width and the height of the frame to
determine the cutout dimensions necessary for the opening in
the wall. The depth of the frame will depend on the depth of
the wall. The finished frame must be set in the inside wall. The
frame has to be squared and leveled. Remember the frame has
to be nailed securely to the wall studs.
A
typical wood framing
A. Wall stud
B. Frame or back-up strip

INSTALLATION INSTRUCTIONS

B
3 Now to install, insert the unit into the wall opening. Make sure
that the cabinet is at least 1/2" inch inside the room. Also the
side louvers should not be blocked. This is to have proper air
circulation in and around the compressor.
4 The cabinet should be tilted 1/4" outside so as to drain the
excess dehumidified water.
5 Properly insulate any opening between the casing and the
frame.
6 Use external wall brackets if needed.
7 If needed,install molding around room side of cabinet.
Seal small openings around window with gum-type sealer.
A
A. Wall
B. Level
C. Casing
CAUTION: If, after completing these steps, the unit appears to be loose or
if you are unsure the unit is properly installed,contact a qualified installer.
B
C
5