Advertisement
Quick Links
213.3mm
LEGEND KIT
'LEFT'
- 1 OF
'RIGHT'
- 1 OF
'FORWARD'
- 2 OF
'BACK'
- 2 OF
'BLANK'
- 1 OF
This product may contain substances that can be hazardous to the environment if not disposed of
correctly. Electrical and electronic equipment should never be disposed of with general household
waste but must be separated for its correct treatment and recovery. Where possible, recycle your
packaging.
IMPORTANT INFORMATION
It is recommended that the luminairies are installed and fitted by a qualified electrician, ensuring the
installation complies to current IEE wiring regulations.
These instructions should be read carefully and retained after installation for future reference and
maintenance.
Do not install this product on damp or newly plastered surfaces.
The LEDs in this fitting are not replaceable.
Ensure all electrical connections are secure and that there are no loose strands.
This product is NOT dimmable.
Do not connect battery supply until 220/240V A.C. supply is permanently fed and lamp fitted.
Allow 24 hours charge before running lamp in emergency mode.
APPROVALS AND CLASSIFICATIONS
www.orlight.com | 01923 851 890
INSTALLATION SHEET
EXIT-LUME-CW/SUS
315mm
305.6mm*150mm
53mm
44.9mm
168.4mm
12.3mm
ALWAYS SWITCH
OFF THE MAINS
SUPPLY BEFORE
INSTALLATION
OR SERVING
Advertisement
Related Manuals for Orlight EXIT-LUME-CW/SUS
Summary of Contents for Orlight EXIT-LUME-CW/SUS
- Page 1 Ensure all electrical connections are secure and that there are no loose strands. This product is NOT dimmable. Do not connect battery supply until 220/240V A.C. supply is permanently fed and lamp fitted. Allow 24 hours charge before running lamp in emergency mode. APPROVALS AND CLASSIFICATIONS www.orlight.com | 01923 851 890...
- Page 2 Primary 240V 50Hz. Class II “L” Live (Brown) Wire - Brown cable to connection marked “L” Earth (Green/Yellow) “N” Neutral (Blue) Wire - Blue cable to connection marked “N” THIS IS A CLASS I PRODUCT AND MUST BE EARTHED. www.orlight.com | 01923 851 890...
- Page 3 All information contained within these installation instructions manual is provided in good faith. Orlight shall not be held responsible for any losses incurred as a result of the Customer’s failure to follow the instructions manual thoroughly and in its entirety or failing to inspect the product for miss- ing parts and/or any defects prior to installation.
Need help?
Do you have a question about the EXIT-LUME-CW/SUS and is the answer not in the manual?
Questions and answers