Subscribe to Our Youtube Channel
Related Manuals for Champion Power Equipment CPE190F-2-ES
Summary of Contents for Champion Power Equipment CPE190F-2-ES
- Page 1 OWNER’S MANUAL & OPERATING INSTRUCTIONS 439cc REPLACEMENT ENGINE MODEL NUMBER CPE190F-2-ES SAVE THESE INSTRUCTIONS Important Safety Instructions MADE IN CHINA are included in this manual. REV CPE190F-2-ES-20220719...
- Page 2 AN IMPORTANT MESSAGE ABOUT TEMPERATURE: Your Champion Power Equipment product is designed and rated for continuous operation at ambient temperatures up to 40°C (104°F). When your product is needed your product may be operated at temperatures ranging from -15°C (5°F) to 50°C (122°F) for short periods.
-
Page 3: Table Of Contents
CPE190F-2-ES 439cc REPLACEMENT ENGINE TABLE OF CONTENTS Introduction ......Troubleshooting ...... -
Page 4: Introduction
INTROdUCTION Introduction Congratulations on your purchase of a Champion Power Equipment product. Champion Power Equipment and Champion Engine Technology designs, builds, and supports all of our products to strict specifications and guidelines. With proper product knowledge, safe use, and regular maintenance, this product should bring years of satisfying service. -
Page 5: Manual Conventions
CPE190F-2-ES ENGLISH MANUAL CONVENTIONS This manual uses the following symbols to help differentiate between different kinds of information. The safety symbol is used with a key word to alert you to potential hazards in operating and owning power equipment. Follow all safety messages to avoid or reduce the risk of serious injury or death. -
Page 6: Safety Rules
CPE190F-2-ES ENGLISH SAFETy RULES WARNING dANGER Read this manual thoroughly before operating your Rotating parts can entangle hands, feet, hair, engine. Failure to follow instructions could result in clothing and/or accessories. Traumatic amputation or serious injury or death. severe laceration can result. - Page 7 CPE190F-2-ES ENGLISH SAFETy RULES WARNING dANGER Rapid retraction of the starter cord will pull hand and Fuel and fuel vapors are highly flammable and arm towards the engine faster than you can let go. extremely explosive. Unintentional startup can result in entanglement, Fire or explosion can cause severe burns or death.
-
Page 8: Controls And Features
Recoil Starter – Used to start the engine. (11) Oil Drain Bolt – Remove to drain engine oil. Throttle – Controls engine speed Parts Included Your CPE190F-2-ES Gasoline Powered Engine ships with the following parts: Other – Spark Plug Socket... -
Page 9: Assembly
CPE190F-2-ES ENGLISH ASSEMBLy Add Engine Oil Add Engine Oil Cont’d. CAUTION CAUTION The engine is equipped with a low oil shut-off DO NOT attempt to crank or start the engine before sensor and will stop when the oil level in the it has been properly filled with the recommended crankcase falls below the threshold level. -
Page 10: Add Engine Fuel
CPE190F-2-ES ENGLISH ASSEMBLy Add Fuel Add Fuel Cont’d. 1. Use clean, fresh, regular unleaded fuel with a NOTE minimum octane rating of 85 and an ethanol content Our engines work well with 10% or less ethanol of less than 10% by volume. -
Page 11: Operation
CPE190F-2-ES ENGLISH OPERATION NOTE Starting the Engine 1. Make certain the engine is on a flat, level surface. If the engine will not be used for a period of two (2) 2. Rotate engine switch to “ON” position (A). weeks or longer, please see the Storage section for 3. -
Page 12: Maintenance And Storage
CPE190F-2-ES ENGLISH MAINTENANCE ANd STORAGE Spark Plugs The owner/operator is responsible for all periodic maintenance. 1. Remove the spark plug cable from the spark plug. 2. Use a spark plug socket to remove the plug. WARNING 3. Inspect the electrode on the plug. It must be clean and not worn to produce the spark required for ignition. -
Page 13: Cleaning
5. Add a fuel stabilizer into the fuel tank. operating in adverse conditions. Contact our help line 6. Change the oil. to locate the nearest Champion Power Equipment 7. The fuel valve needs to be in the off position. authorized service dealer for your engine maintenance 8. -
Page 14: Troubleshooting
CPE190F-2-ES ENGLISH TROUBLESHOOTING Problem Cause Solution No fuel Add fuel Engine will not start Faulty spark plug Replace spark plug Fill crankcase to the proper level Low oil level Place engine on a flat, level surface Engine will not start;... -
Page 15: Specifications
CPE190F-2-ES ENGLISH SPECIFICATIONS Spark Plugs Engine Specifications OEM spark plug: NHSP F6RTC – Engine ....439 cc OHV CPE Replacement spark plug: NGK BPR6ES or equivalent –... -
Page 16: Parts Diagram
CPE190F-2-ES ENGLISH SPECIFICATIONS Parts diagram... -
Page 17: Parts List
CPE190F-2-ES ENGLISH SPECIFICATIONS Part Number Description Part Number Description 21.061300.00 Handle, Recoil, Soft 23.040010.00 Bolt, Rocker Arm 1.5789.0608 Flange Bolt M6 x 8 45.040001.00 Retainer, Intake Valve Spring 46.061100.00.2 Cover, Recoil Starter, Black 45.040007.00 Retainer, Exhaust Valve Spring 45.060005.00 Spring, Recoil Starter 45.040008.00...
Need help?
Do you have a question about the CPE190F-2-ES and is the answer not in the manual?
Questions and answers