Champion Power Equipment CPE188F-ES Owner's Manual & Operating Instructions

Champion Power Equipment CPE188F-ES Owner's Manual & Operating Instructions

389cc replacement engine

Advertisement

Quick Links

OWNER'S MANUAL & OPERATING INSTRUCTIONS
389cc
REPLACEMENT ENGINE
MODEL NUMBER
CPE188F-ES
SAVE THESE INSTRUCTIONS
Important Safety Instructions
MADE IN CHINA
are included in this manual.
REV CPE188F-ES-20220719

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CPE188F-ES and is the answer not in the manual?

Questions and answers

Summary of Contents for Champion Power Equipment CPE188F-ES

  • Page 1 OWNER’S MANUAL & OPERATING INSTRUCTIONS 389cc REPLACEMENT ENGINE MODEL NUMBER CPE188F-ES SAVE THESE INSTRUCTIONS Important Safety Instructions MADE IN CHINA are included in this manual. REV CPE188F-ES-20220719...
  • Page 2 AN IMPORTANT MESSAGE ABOUT TEMPERATURE: Your Champion Power Equipment product is designed and rated for continuous operation at ambient temperatures up to 40°C (104°F). When your product is needed your product may be operated at temperatures ranging from -15°C (5°F) to 50°C (122°F) for short periods.
  • Page 3: Table Of Contents

    CPE188F-ES 389cc REPLACEMENT ENGINE TABLE OF CONTENTS Introduction ......Troubleshooting ......
  • Page 4: Introduction

    INTROdUCTION Introduction Congratulations on your purchase of a Champion Power Equipment product. Champion Power Equipment and Champion Engine Technology designs, builds, and supports all of our products to strict specifications and guidelines. With proper product knowledge, safe use, and regular maintenance, this product should bring years of satisfying service.
  • Page 5: Manual Conventions

    CPE188F-ES ENGLISH MANUAL CONVENTIONS This manual uses the following symbols to help differentiate between different kinds of information. The safety symbol is used with a key word to alert you to potential hazards in operating and owning power equipment. Follow all safety messages to avoid or reduce the risk of serious injury or death.
  • Page 6: Safety Rules

    CPE188F-ES ENGLISH SAFETy RULES WARNING dANGER Read this manual thoroughly before operating your Rotating parts can entangle hands, feet, hair, engine. Failure to follow instructions could result in clothing and/or accessories. Traumatic amputation or serious injury or death. severe laceration can result.
  • Page 7 CPE188F-ES ENGLISH SAFETy RULES WARNING dANGER Rapid retraction of the starter cord will pull hand and Fuel and fuel vapors are highly flammable and arm towards the engine faster than you can let go. extremely explosive. Unintentional startup can result in entanglement, Fire or explosion can cause severe burns or death.
  • Page 8: Controls And Features

    Recoil Starter – Used to start the engine. (11) Oil Drain Bolt – Remove to drain engine oil. Throttle – Controls engine speed Parts Included Your CPE188F-ES Gasoline Powered Engine ships with the following parts: Other – Spark Plug Socket...
  • Page 9: Assembly

    CPE188F-ES ENGLISH ASSEMBLy Add Engine Oil Add Engine Oil Cont’d. CAUTION CAUTION The engine is equipped with a low oil shut-off DO NOT attempt to crank or start the engine before sensor and will stop when the oil level in the it has been properly filled with the recommended crankcase falls below the threshold level.
  • Page 10: Add Engine Fuel

    CPE188F-ES ENGLISH ASSEMBLy Add Fuel Add Fuel Cont’d. 1. Use clean, fresh, regular unleaded fuel with a NOTE minimum octane rating of 85 and an ethanol content Our engines work well with 10% or less ethanol of less than 10% by volume.
  • Page 11: Operation

    CPE188F-ES ENGLISH OPERATION NOTE Starting the Engine 1. Make certain the engine is on a flat, level surface. If the engine will not be used for a period of two (2) 2. Rotate engine switch to “ON” position (A). weeks or longer, please see the Storage section for 3.
  • Page 12: Maintenance And Storage

    CPE188F-ES ENGLISH MAINTENANCE ANd STORAGE Spark Plugs The owner/operator is responsible for all periodic maintenance. 1. Remove the spark plug cable from the spark plug. 2. Use a spark plug socket to remove the plug. WARNING 3. Inspect the electrode on the plug. It must be clean and not worn to produce the spark required for ignition.
  • Page 13: Cleaning

    5. Add a fuel stabilizer into the fuel tank. operating in adverse conditions. Contact our help 6. Change the oil. line to locate the nearest Champion Power Equipment 7. The fuel valve needs to be in the off position. authorized service dealer for your engine maintenance 8.
  • Page 14: Troubleshooting

    CPE188F-ES ENGLISH TROUBLESHOOTING Problem Cause Solution No fuel Add fuel Engine will not start Faulty spark plug Replace spark plug Fill crankcase to the proper level Low oil level Place engine on a flat, level surface Engine will not start;...
  • Page 15: Specifications

    CPE188F-ES ENGLISH SPECIFICATIONS Spark Plugs Engine Specifications OEM spark plug: NHSP F6RTC – Engine ....389 cc OHV CPE Replacement spark plug: NGK BPR6ES or equivalent –...
  • Page 16: Parts Diagram

    CPE188F-ES ENGLISH SPECIFICATIONS Parts diagram...
  • Page 17: Parts List

    CPE188F-ES ENGLISH SPECIFICATIONS Part Number Description Part Number Description 21.061300.00 Handle, Recoil, Soft 23.040010.00 Bolt, Rocker Arm 1.5789.0608 Flange Bolt M6 x 8 45.040001.00 Retainer, Intake Valve Spring 46.061100.00.2 Cover, Recoil Starter, Black 45.040007.00 Retainer, Exhaust Valve Spring 45.060005.00 Spring, Recoil Starter 45.040008.00...

Table of Contents