How To Operate The Heating Bath; Choose The Appropriate Heat Transfer Medium; Plus Heating Bath - Labtech EV400 Series User Manual

How to operate the heating bath

Choose the appropriate heat transfer medium

Bath Type Temp. Range
Water bath Ambient~100℃
Oil Bath 100℃~210℃
Pour into the heating bath an appropriate volume of liquid. Connect the unit to the power, press the green button
to switch on the unit. Red to switch off.
HB-03PLUS Heating Bath
SET: Set or check temperature, holding time and other parameters.
SHIFT/AT: In set interface, the key is a digital transposition key. In other interface, press and hold the key for 6
seconds to enter or the quit auto-calibration system.
DEC/RERUN: In set interface, press the key to decrease value, press and hold it to speed up the value
decrease. In other interface, press and hold the key for 3 seconds can rerun the system after finishing the
heating phase.
INC/LED: In set interface, press the key to increase value, press and hold it to speed up the value increase. In
another interface, press the key to backlight on/off.
Heat Transfer
Remark
Medium
Hardness of the water must be as low as possible;
Water
When using deionized water, please add 0.2%
Na2B4O7*10H2O solvent for anti-corrosion.
Viscosity of the silicone oil must be below 50
Silicone Oil
centipoises.
www.labtechsrl.com
EV400 SERIES – User Manual
Page 29 of 39