Page 1
EBK250 This manual covers the operation of: VAC-419 EBK250 Cordless Electric Turbo Brush VAC-421 Power Tube Battery Pack & Telescopic Wand VAC-422 Battery Charger for Power Tube All items are available for purchase separately or as part of K-VAC-419 kit...
Page 2
• • • • • This device complies with the following EG directives: • 2014/35/EU – Low Voltage Directive • • 2014/30/EU – EMC directive • 2011/65/EG – RoHS directive • Attention! • Do not use the device without • having read the instructions for use •...
ATTENTION! This device is not suitable for the recovery of hazardous dust. • This device is intended for dry use only and must not be used or stored • outdoors in wet conditions. Use only original manufacturer’s parts. Use of non-original •...
POWER BRUSH Wand release button Headlight Brush release - twist to remove the brush for easy cleaning. Hair and lint can be cut away with scissors taking care not to cut the roller brushes.
POWER WAND To your On/Off vacuum Switch* hose Charger input Status Display / Battery charge indicator * On/Off Switch Operation • Short Press to display battery charge level. • Long Press to turn on or off. CHARgER Click into the power brush...
Page 6
Do not vacuum up heavy, hard or sharp-edged objects. You could block • and damage the electric brush. Don’t operate the electric brush over exposed cables. • The electrical connector must be checked regularly for damage. If there • is any damage, the electrical connection piece must be replaced immediately by a qualified small appliance repair professional.
Charging Shipping a fully charged Lithium-Ion Battery is prohibited. A new battery just ‘out of the box’ will only have a partial charge. To ensure a full battery charge, completely charge the battery before using. It is always best to disconnect the charger from the battery after full charge has been achieved.
Need help?
Do you have a question about the VAC-419 and is the answer not in the manual?
Questions and answers