Related Manuals for CircuPool TOTALBalance
Summary of Contents for CircuPool TOTALBalance
- Page 1 TOTAL Balance Swimming Pool pH Management - Installation and Operation Guide pH Control System with CO Infusion Advanced Swimming Pool Sanitation Rev: 2024-06...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SAFETY INSTRUCTIONS HELPFUL HINTS INTRODUCTION System Package Contents Tools Required System Overview INSTALLATION OPERATION Synchronization Controls (Quick-Reference) Initial Set-Up General Operation CO2 Saver Mode Cylinder Exchange Troubleshooting INFUSION CHART WARRANTY... -
Page 3: Safety Instructions
• If you are using a variable speed pump, ensure the TOTALBalance system’s pressure sensor gets triggered when setting low pump speeds. It is recommended to make sure there is at least 4-5 lbs. of pressure in the filter and 1700 rpm on the pump. -
Page 4: Introduction
Important Notice: The CO2 Infusion Injector and the Pressure Sensor fitting are both designed to fit most swimming pool pumps with industry-standard ¼-18 NPSM Straight pipe drain plugs. This includes pumps manufactured by: CircuPool® SmartFlo Pentair® Sta-Rite® Hayward®... -
Page 5: Installation
INSTALLATION Figure 2 - Detail 24vDC Power Supply Infusion Setting System “Active” Pressure Sensor Indicator Light (“RED” Fitting) “Power” Indicator Light CO2 Infusion Injector (“BLACK” Fitting) “On/Off” Switch Flow Gauge CO2 Injection Mode Flow Adjustment Knob “RIGHT RED” Port (Pressure Sensor line) Power Receptacle “CENTER BLACK”... - Page 6 V. Insert the other end of the tubing into the fitting of the “CENTER BLACK” port on the bottom of the Controller. (See Figure 2, above) 4. Installing the Pressure-Sensor and connecting the poly-urethane tubing. I. Remove the drain plug from the pump impeller housing drain port (this is typically the drain plug towards the rear of the pump).
-
Page 7: Operation
I. Ensure regulator fittings are securely attached to the cylinder valves. II. Ensure the BLUE poly-urethane tubing from the regulator to the Controller is securely attached. III. Open the main valves on the cylinders by turning the valves counter-clockwise until they are completely open then turn them clockwise ½... -
Page 8: Initial Set-Up
Initial Set-Up TOTAL Balance pH system controller must now be set. Initial set-up will be based on the InpHusion® Chart. This small chart has an adhesive backing – be sure to peel attach the chart to the inside of the controller cover for future reference. -
Page 9: Co2 Saver Mode
CO2 Saver Mode The system mode switch should initially be set to CO2 Standard for a minimum of 14 days. After the pool’s pH has been successfully stabilized over that time and the pool water has become “saturated”, you can switch to CO2 Saver mode. -
Page 10: Infusion Chart
Infusion Chart This copy of the infusion chart has been added here for future reference. Be sure to adhere the included physical copy of the chart to the unit’s cover or in a protected location near the equipment for convenient access during use. CO2 Infusion Chart Patent US 7,537,707 B2 Minimum Pump Run Time (Hours) -
Page 11: Warranty
No packages will be accepted without a RMA number. 2. Should a defect in any item or part covered by the warranty become evident during the warranty's term, CircuPool Products will at its sole discretion repair or replace such item or part. CircuPool Products reserves the right to replace defective parts with new or refurbished parts.
Need help?
Do you have a question about the TOTALBalance and is the answer not in the manual?
Questions and answers