Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CircuPool RJ Series
Summary of Contents for CircuPool RJ Series
-
Page 2: Table Of Contents
Overview INTRODUCTION Installing the Control Module Installing the Electrolytic Cell Congratulations on your recent purchase of a CircuPool RJ Series Wiring Saltwater Chlorine Generator. CircuPool’s high performance systems Installation Checklist offer escape from the routine of manual pool chlorination and sanitization. -
Page 3: Safety Instructions
When replacing the cell, only use replacement cells having a label that clearly states that it is the replacement for this RJ Series model. For outdoor pools, chlorine residuals can be protected from destruction bysunlight by addition of stabilizer (cyanuric acid). -
Page 4: Installing The Control Module
The Electrolytic Cell is to be fitted into the return line as the last piece of CircuPool RJ series has been designed to easily wire into typical in- equipment the water passes through before returning to the pool: after the ground pool systems. -
Page 5: Operation
□You have checked all connections and joints for leaks. the salt (while the RJ Series is off). Do not throw the salt bag into the □Pool has properly balanced water chemistry. -
Page 6: Salt Levels
OPERATION, continued Salt may take 24 - 48 hours to dissolve in summer, and longer in Before adding salt, check your water for any existing salt content and winter. Finer granules of salt will dissolve faster than compressed add according to the chart below. If too little salt is added, the result pellets. -
Page 7: Using The Control Panel
Most electronic testers are subject to a variation of about situations, the Internal timer can run the unit independently of your fifteen percent. The CircuPool unit works well in a wide salinity range so a pump timer, follow the steps below: great deal of precision is not required. -
Page 8: Maintenance
• Add Salt • Nitrates and Phosphates The CircuPool RJ Series will automatically let you know if salinity has fallen These chemicals can cause extremely high chlorine demands and will deplete below acceptable levels. When illuminated for more than two hours, add chlorine from your pool. -
Page 9: Maintaining The Electrolytic Cell
Replacements are easily the cell to the return line plumbing. switched out. To ensure quality and value, only genuine CircuPool 4) Pull entire cell away from the barrel unions. replacement parts may be used. -
Page 10: Helpful Hints
Definitions www.circupool.com/help. Algae Proper operation of the chlorine generator can be easily verified by Plant-like organisms which grow in water.Especially active in summer inspecting the Electrolytic Cell. The chlorine being produced will appear as a conditions, where chlorine disinfectant level is too low to destroy fog at one end of the plates. -
Page 11: Troubleshooting
TROUBLESHOOTING For more detailed information and extensive troubleshooting, visit Water Fault LED Illuminated www.circupool.com/help. • The Control Module has stopped generating chlorine. Check that the Electrolytic Cell is completely filled with water. • If there is adequate flow and the LED is still on, check that the... -
Page 12: Warranty
5. Damage due to improper service. 6. Damage caused by insects or natural elements. This warranty is applicable to parts only and CircuPool and Compu Pool Products USA Inc., its agents, employees, and affiliates expressly disclaim responsibility for loss, damage, or injuries to persons or property arising from the use, or installation of equipment.
Need help?
Do you have a question about the RJ Series and is the answer not in the manual?
Questions and answers