TRP TT HYDRAULIC Installation Instructions

TT HYDRAULIC
INSTALLATION INSTRUCTIONS
SAFETY WARNINGS & INFORMATION
WARNING - This braking system was designed for use on a single rider bicycle. Use of this system on any other vehicle or apparatus will void the
warranty. possibly causing you great personal harm or injury.
WARNING - Disc brakes, calipers and rotors get VERY HOT during regular use. DO NOT touch or attempt to service the rotor or caliper assembly until
you've allowed for sufficient cooling to occur.
WARNING - These disc brakes offer a significant increase in performance over traditional cable actuated systems. Follow the break-in recommen-
dations listed in this manual, allow yourself time to learn and become accustomed to the braking characteristics.
WARNING - Leaking oil indicates a potential BRAKE FAILURE. If you're system is leaking oil stop immediately and determine the nature of the
problem. DO NOT continue to ride a leaking system.
WARNING - If your bike is involved in a fall or crash, fully check the brake function including: the lever, caliper and rotor are securely attached to the
bike, pads are correctly installed and functioning, the cable. (if applicable) is operating smoothly and the lever feels firm when applying the brake.
Always have a qualified mechanic check the brakes if you have any doubts.
WARNING - Pad thickness must be at least 2.2mm . Confirm this before each ride.
Keep pads clean and free of oil or hydraulic fluid. If pads become contaminated, discard and replace.
CAUTION - Read this manual completely before attempting to install or work on your TRP brakes. If you are unfamiliar with any element of assembly
or maintenance of this braking system please consult a qualified mechanic for assistance.
CAUTION - Only use TRP or TEKTRO branded replacement Mineral Oil when servicing the brakes. Other disc brake fluids, ESPECIALLY DOT based oils,
will harm the system and compromise braking performance.
CAUTION - Cleanliness is a very important part of any maintenance of a TRP disc brake. If the pads or rotor become contaminated with oil, or if the
system becomes contaminated with impurities, braking performance will be greatly impaired.
CAUTION - As with any oil, precautions in handling and clean up of any spills should be handled according to accepted best practices as
governed by your state or country. Our Mineral oil is non-toxic, but clean up any spills promptly and completely.
If Mineral Oil gets in your eyes IMMEDIATELY FLUSH WITH WATER for several minutes and go to the hospital. If Mineral oil gets on your skin RINSE IMME-
DIATELY with soap and water. Do not inhale Mineral Oil, it is harmful. If inhaled move to a well ventilated environment and proceed to the hospital
for appropriate care. If you ingest Mineral oil it may cause vomiting and/or diarrhea.
TRP hydraulic disc brakes are warranted against manufacturing defects in materials and / or workmanship for a period of two years from the date
of original retail purchase.
Not covered under this warranty is damage resulting from improper installation, adjustment or maintenance, lack of maintenance, alterations,
crashes or use judged by Tektro to be excessive or abusive. For warranty related questions or more information please contact a TRP Service
Center or e-mail at info@trpbrakes.com
ADAPTER AND HARDWARE
FlatMount Adapter Orientations
FM1.1 F140/F160 Adapter
70
M5x13, 2pcs M5x14, 2pcs
Torque Spec:
FlatMount bolts:5-7Nm(44-62 In-lb)
Disc Rotor bolts:4-6Nm(35-53 In-lb)
FlatMount Rear Adapter & Bolt Lengths
FM1.1 R160 Adapter
M5x13, 2pcs
34
Torque Spec:
FlatMount bolts:5-7Nm(44-62 In-lb)
Disc Rotor bolts:4-6Nm(35-53 In-lb)
140 Rotor
M5x32, 2pcs
32
also available
M5x17 M5x37
M5x22 M5x42
M5x27
FlatMount Rear 160 Rotor
Brake Lever
160 Rotor
Brake levers may be swapped to achieve
desired ergonomics. Please see online
videos at www.trpcycling.com
www.trpcycling.com
Edition：2023.12.28