Download Print this page
Hide thumbs Also See for SA40:

Advertisement

Available languages

Available languages

Quick Links

IOTAVX SA40 + PA40 Set
To utilize the full potential of the SA40 & PA40 set, please connect the components as
follows:
1. Set the SA40 to "MONO (Bridged)" using the rear panel "Amplifier Mode" switch.
2. Set the PA40 to "MONO (Bridged)" using the rear panel "Amplifier Mode" switch.
3. Use a mono RCA cable to connect the left RCA output "PRE OUT (L)" of the SA40
to the left RCA input "AMP IN (L)" of the PA40.
4. Connect your right speaker to the two outer speaker terminals of the SA40 using a
speaker cable. Please note the polarity (+ and -).
5. Connect your left speaker to the two outer speaker terminals of the PA40 using a
speaker cable. Please note the polarity (+ and -).
We hope you enjoy the devices and will be happy to answer any questions you may
have by telephone (+49 7232 3640155) or by email (info@iotavx.com).
English: Page 1 / Deutsch: Seite 2
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the SA40 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for IOTAVX SA40

  • Page 1 2. Set the PA40 to “MONO (Bridged)” using the rear panel “Amplifier Mode” switch. 3. Use a mono RCA cable to connect the left RCA output "PRE OUT (L)" of the SA40 to the left RCA input "AMP IN (L)" of the PA40.
  • Page 2 IOTAVX SA40 + PA40 Set English: Page 1 / Deutsch: Seite 2 Um das volle Potential des SA40 & PA40 Sets zu nutzen, schließen Sie die Komponenten bitte wie folgt an: 1. Stellen Sie den SA40 mit dem „Amplifier Mode“-Schalter auf „MONO (Bridged)“.

This manual is also suitable for:

Pa40 setSa40pa40