NICREW HyperReef 30 Instruction Manual

Advertisement

NICREW
HyperReef 30
Instruc�on Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HyperReef 30 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for NICREW HyperReef 30

  • Page 1 NICREW HyperReef 30 Instruc�on Manual...
  • Page 2: Important Safety Instruc�Ons

    Important Safety Instruc�ons WARNING - To guard against injury, basic safety precau�on should be observed including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS. • DO NOT look directly at LEDs regardless of intensity. • DO NOT SUBMERGE THE LAMP UNIT. The light is NOT WATERPROOF; water can permanently damage it.
  • Page 3: Installa�On

    Installa�on • Assemble the tank mount as instructed (fig. 2). • Mount on the rear wall of the tank. • Locate the two male plugs on the wired controller and connect them to their coordinated female counterparts on the fixture as illustrated in fig.
  • Page 4 For Hanging Op�on Screw hanging kit into the four corner holes of the unit and secure the hanging wire to the ceiling or other mount. NOTE: The higher you hang your light over the water, the wider the light spread - but the lower the light intensity.
  • Page 5 NOTE: • 6 intensity levels adjustable: the intensity of each channel can be set to 5%, 20%, 40%, 60%, 80%, 100%. • The blue channel light can be turned off totally in daylight mode. • When the light is turned on again, it will return to the previous se�ng it was in.
  • Page 6: Maintenance

    Maintenance • Always turn off light fixture and unplug from outlet prior to performing any maintenance. • Water spray and water scale can create an electrical and fire safety hazard if allowed to collect on the fixture. To prevent hazard, use over covered aquarium only and clean the fixture regularly.
  • Page 7: Warranty

    Warranty NICREW products carry a one-year limited warranty from the date of purchase. If your product is within warranty and you require a replace- ment part or service, please contact us at support@nicrew.com.

Table of Contents