Jumpers Setup - ASROCK X533 User Manual

2.7 Jumpers Setup

The illustration shows how jumpers are setup.
When the jumper cap is placed on pins, the
jumper is "Short". If no jumper cap is placed on
pins, the jumper is "Open". The illustration
shows a 3-pin jumper whose pin1 and pin2
are "Short" when jumper cap is placed on
these 2 pins.
Jumper
FSB_SEL0
(see p.7 item 26)
Note: The setting of the CPU front side bus frequency of this motherboard is by
means of the adjustment of jumper-setting. Please follow the figures above
to set the CPU front side bus frequency.
PS2_USB_PWR1
(see p.7 item 22)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
CLRCMOS1
(see p.7 item 17)
Note: These solder points allow you to clear the data in CMOS. The data in CMOS
includes system setup information such as system password, date, time,
and system setup parameters. To clear and reset the system parameters to
default setup, please turn off the computer and unplug the power cord, then
short the solder points for 3 seconds by using metal material, e.g., a paper clip.
Please remember to remove the paper clip after clearing the CMOS.
Setting
1_2
FSB_SEL0
FSB 400MHz
1_2
+5V
Clear CMOS
solder points
Short
FSB_SEL0
FSB 533MHz
2_3
Short pin2, pin3 to enable
+5VSB (standby) for PS/2
+5VSB
or USB wake up events.
Open
2_3