USCutter MH200 User Manual page 2

SAFETY INFORMATION
IMPORTANT: READ THIS SECTION IN FULL BEFORE PROCEEDING
This product is designed for use as a cutter/plotter for vinyl and similar density materials. Use of the
product in ways for which it was not designed can be very dangerous and will void the warranty.
The product has fast moving parts and uses sharp blades. To avoid injury, keep fingers, hands, hair, loose
clothing and other body parts away from the carriage head, rollers and other moving parts when the
cutter is powered on.
Do not disassemble, repair, or remodel the plotter unless specifically instructed to do so by a qualified
technician. Such action may cause electric shock or a fire hazard due to current leakage.
Use only the provided power supply and connect only to a properly grounded three prong wall outlet.
Failure to do so may result in electrical shock or fire.
Do not use the cutter in an area where it will be exposed to water, rain, snow or other liquids that may get
into the cutter. Fluids falling into the cutter may cause electrical shock.
If the cutter generates sparks, smoke, strange odor or otherwise functions abnormally, discontinue use,
disconnect the cutter from the wall socket and contact the dealer from which you purchased the product.
Never attempt to perform repair work yourself unless under the direction of a qualified service technician.