Ide Configuration - ASROCK P4VM890 - V1.1 User Manual

3.3.4 IDE Configuration

3.3.4 3.3.4 IDE Configuration IDE Configuration IDE Configuration
3.3.4 3.3.4 IDE Configuration
BIOS SETUP UTILITY
Advanced
IDE Configuration
OnBoard IDE Controller [Enabled]
[RAID]
SATA Operation Mode
Primary IDE Master [Hard Disk]
Primary IDE Slave [Not Detected]
Secondary IDE Master [Not Detected]
Secondary IDE Slave [Not Detected]
SATA 1 [Not Detected]
SATA 2 [Not Detected]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
OnBoard IDE Controller
Use this item to enable or disable onboard IDE controller. Configuration
options: [Enabled] and [Disabled].
SATA Operation Mode
Use this item to adjust SATA Operation Mode. Please set this item to [RAID]
if you want to operate RAID functions with Windows
please set this item to [non-RAID].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "Primary IDE Master" as the example in the following instruction,
which can be applied to the configurations of "Primary IDE Slave", "Sec-
ondary IDE Master", and "Secondary IDE Slave" as well.
BIOS SETUP UTILITY
Advanced
Primary IDE Master
Device :Hard Disk
Vendor :ST340014A
Size :40.0 GB
LBA Mode :Supported
Block Mode :16Sectors
PIO Mode :4
Async DMA :MultiWord DMA-2
:Ultra DMA-5
Ultra DMA
S.M.A.R.T. :Supported
Type [Auto]
[Auto]
LBA/Large Mode
[Auto]
Block (Multi-Sector Transfer)
[Auto]
PIO Mode
[Auto]
DMA Mode
[Disabled]
S . M . A . R . T .
[Disabled]
32Bit Data Transfer
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
To enable or disable
the onboard IDE
controller.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
® 2000 / XP. Otherwise,
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
3 1 3 1
3 1 3 1 3 1