Ide Configuration - ASROCK P45XE User Manual

ACPI HPET Table
Use this item to enable or disable ACPI HPET Table. The default value is
[Disabled]. Please set this option to [Enabled] if you plan to use this
motherboard to submit Windows
3 . 4 . 5 3 . 4 . 5

IDE Configuration

IDE Configuration
3 . 4 . 5 3 . 4 . 5 IDE Configuration 3 . 4 . 5 IDE Configuration IDE Configuration
BIOS SETUP UTILITY
Advanced
IDE Configuration
SATAII Configuration
Configure SATAII as
SATAII 1
SATAII 2
SATAII 3
SATAII 4
SATAII 5
SATAII 6
IDE1 Master
IDE1 Slave
AHCI CD/DVD Boot Time out
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
SATAII Configuration
Please select [Compatible] when you install legacy OS. If native OS (Windows
2000 / XP) is installed, please select [Enhanced]. Then in the option "Config-
ure SATAII as", you are allowed to set the selection to [RAID] if you plan to
enable RAID function. Configuration options: [IDE], [AHCI] and [RAID]. The
default value is [IDE].
If you select [AHCI] or [RAID] mode, the option "Hot Plug" will appear. You are
allowed to use the Hot Plug function under Windows environment if this option
is enabled. Configuration options: [Enabled] and [Disabled].
* RAID option is only supported for P45XE-WiFiN / P45XE-R.
1. AHCI (Advanced Host Controller Interface) supports NCQ and
other new features that will improve SATA disk performance
but IDE mode does not have these advantages.
2. RAID option is only for P45XE-WiFiN / P45XE-R.
OnBoard IDE Controller
Use this item to enable or disable onboard IDE controller. The default value
is [Enabled].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "Primary IDE Master" as the example in the following instruction.
Vista certification.
® TM
Options
Disabled
[Enhanced]
Compatible
[IDE]
Enhanced
[Hard Disk]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
Select Screen Select Screen
[Not Detected]
Select Item Select Item
+- +- Change Option Change Option
[35]
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
6 9 6 9 6 9
6 9 6 9