ASROCK N68-GS UCC User Manual page 36

CPU, and some CPU, including quad-core CPU, can also increase L3 cache
size up to 6MB, which means you can enjoy the upgrade CPU performance
with a better price. Please be noted that UCC feature is supported with
AM2+ / AM3 CPU only, and in addition, not every AM2+ / AM3 CPU can
support this function because some CPU's hidden core may be
malfunctioned.
Processor Maximum Frequency
It will display Processor Maximum Frequency for reference.
North Bridge Maximum Frequency
This option appears only when you adopt Phenom CPU. It will display North
Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is rec-
ommended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
L3 Cache Allocation
Unlock CPU Core
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for system stability, it is not recommended to adjust the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for safety and system stability, it is not recommended to adjust the value of
this item.
If AUTO, multiplier and
[Disabled] voltage will be left at the
[Auto] rated frequency/voltage. If
Manual, multiplier and
[200]
voltage will be set based
[100]
[Enabled] on User Selection in Setup.
[Enabled]
[Enabled]
[Enabled]
[Auto]
Select Screen Select Screen
[Enabled]
[Disabled] Select Item Select Item
[BSP Only] +- +- Change Option Change Option
[Disabled] F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
x11.5 2300 MHz
F10 F10 Save and Exit Save and Exit
1.300 V
ESC ESC Exit Exit
[Manual]
3 6 3 6 3 6 3 6 3 6