ASROCK N68-GS - V1.1 User Manual page 35

Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is recom-
mended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
L3 Cache Allocation
Processor Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Frequency
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for system stability, it is not recommended to adjust the value of this item.
Processor Voltage
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for safety and system stability, it is not recommended to adjust the value of
this item.
CPU Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for safety
and system stability, it is not recommended to adjust the value of this item.
NB Frequency Multiplier
This option appears only when you adopt Phenom CPU. However, for safety
and system stability, it is not recommended to adjust the value of this item.
Memory Clock
This item can be set by the code using [Auto]. You can set one of the standard
values as listed: [200MHz (DDRII400)], [266MHz (DDRII533)],
[333MHz (DDRII667)] and [400MHz (DDRII800)]. If you adopt Phenom CPU,
there is one more option: [533MHz (DDRII1066)].
If AUTO, multiplier and
[Disabled] voltage will be left at the
rated frequency/voltage. If
[Auto]
Manual, multiplier and
[200]
voltage will be set based
[100]
[Enabled] on User Selection in Setup.
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled] Select Screen Select Screen
[Disabled] Select Item Select Item
[BSP Only] +- +- Change Option Change Option
F1 F1 General Help General Help
x11.5 2300 MHz
F9 F9 Load Defaults Load Defaults
1.300 V
F10 F10 Save and Exit Save and Exit
[Manual]
ESC ESC Exit Exit
[x9.0 1800 MHz]
3 5 3 5 3 5 3 5 3 5