Pro Series Pumps PS-C22 Instruction Manual & Safety Warnings
  1. Manuals
  2. Brands
  3. Pro Series Pumps Manuals
  4. Water Pump
  5. PS-C22
  6. Instruction manual & safety warnings

Pro Series Pumps PS-C22 Instruction Manual & Safety Warnings

Combination primary and backup sump pump system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Table of Contents

Instructions
2
2
2
Items included in system
3
3
3
4
5
5
5
5
5
5
6
Lights and Alarms
6
7
7
8
8
Instruction Manual & Safety Warnings
Combination Primary and Backup Sump Pump System
8
9,10
11
11
11
Testing the System
11
11
11
12
12
12
12
12
Technical support
12
14
Warranty
15
16
Model PS-C22
IMPORTANT: Even if you have the Pro Series™ PS-C22
Combination Sump Pump System installed by someone
Scan the QR code
else, you must read and follow the safety information
for more information
contained in this manual. Failure to do so could result
about the PS-C22
Combination Sump
in property damage, serious injury, or death.
Pump System

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PS-C22 and is the answer not in the manual?

Questions and answers

Related Manuals for Pro Series Pumps PS-C22

Summary of Contents for Pro Series Pumps PS-C22

  • Page 1: Table Of Contents

    Replacement Parts List & Diagram 13 Understanding the Warning Lights and Alarms Troubleshooting Guide Silencing the alarm IMPORTANT: Even if you have the Pro Series™ PS-C22 Warranty during an emergency Combination Sump Pump System installed by someone Scan the QR code...

  • Page 2: Important Safety Warnings And

    Important Safety • MAKE SURE A PROPERLY GROUNDED voice or close enough to come to your aid oxygen gas that may have been emitted RECEPTACLE IS AVAILABLE. This pump when you work near a lead-acid battery. from the battery. Warnings & Instructions is wired with a 3-prong grounded plug.

  • Page 3: Introduction

    Introduction The Combination Sump Pump System For some installations you may need these includes: additional items: The Pro Series pair of pumps combination • A ⅓ HP primary pump with a caged dual • 1½-inch rigid PVC pipe to connect to the system is designed to provide both primary float switch, and a blue piggyback controller existing plumbing...

  • Page 4: Installing The Pipe And Pump

    Installing the Pipe sump pit is not clean, remove as much of the debris 8. Inspect all of the screws on the hose clamps as possible. The pumps are attached to a sump foot of the no-hub couplings (primary and backup and Pump stand (SF2A) to raise them above any debris.

  • Page 5: Battery Instructions

    Battery Instructions the lock washer, washer, then the RED 5. If any of the alarms are sounding, press through several full cycles. The primary POSITIVE (+) wire ring over the bolt. Screw the RESET button on the front of the pump should run for 10 seconds after the A Pro Series standby battery has been the bolt into the hole on the POSITIVE (+)

  • Page 6: Product Operation

    Product Operation Do not obstruct this hole or an air lock may • Press the RESET button for five (5) seconds repeatedly if your main AC pump is broken, prevent the pump from activating, and the to silence these alarms for 24 hours. A or you are experiencing heavy rains and basement will flood.

  • Page 7: Cleaning Battery Terminals

    battery. (In most cases, the pump does not piggyback controller. 8. (a) Plug the charger back into the wall and unplug the AC pump and the blue run continuously, and therefore, you actually outlet. (Provide additional protection for piggyback controller. 2.

  • Page 8: Fuse Alarm

    1. Check the pump plug in the back of the the RESET button on the front of the control control unit to make sure it is firmly panel to silence the alarm. The pump will CHARGER connected. Check the pump wires to make continue to operate even if the reset button FLOAT PUMP...

  • Page 9: Replacing The Primary Pump

    other while one is connected to the battery. valves. Contact Glentronics, Inc. to order check valves with a 1½-inch MPT on one 5. Slowly loosen the no-hub coupling on the end, a 1½-inch SLIP on the other end top of the combination pump assembly to and a predrilled ³/��-inch air bleed hole separate the pipes.
  • Page 10 the handle on the primary pump. Tip the 10. Remove the screws from the strainer on 15. Connect the backup pump to the back of DANGER assembly over the sump pit to drain any the new primary pump and discard them the backup control unit.

  • Page 11: Power Alarm

    19. If any of the alarms are sounding, press The control unit must receive 115 volts AC To silence an alarm, press the RESET button While the pumps the RESET button for 1 second. +/- 5% from the AC outlet. Any voltage lower for one (1) second.

  • Page 12: Using The Remote Notification

    Using the Remote USB DATA PORT MAINTENANCE CHECKLIST Notification This system has a USB port on the side of the Maintenance should be performed 1-2 times controller. The purpose of this port is to allow per year communication with the Pro Series CONNECT THE REMOTE TERMINAL 1.

  • Page 13: Replacement Parts List & Diagram

    Replacement Parts List BOTTOM VIEW PS-C22 Description Part No. Controller for backup pump PHCC1850- CONT-AGM 18 50 Float switch for backup pump FLOAT-DL-MC Enhanced Float Enhanced Dual Float switch with Adjust pump timer from 5-45 seconds controller for AC pump DFC1.5...

  • Page 14: Troubleshooting Guide

    Backup Pump Troubleshooting Guide Primary Pump Troubleshooting Guide DANGER Read safety warnings & instructions before attempting any repairs or maintenance. DANGER Read safety warnings & instructions before attempting any repairs or maintenance. Potential Cause THE PUMP WILL NOT START OR RUN Solutions Potential Cause BATTERY PROBLEM...
  • Page 15 Limited Warranty By opening this package and using this GLENTRONICS, INC. product, you are agreeing to be bound by the terms of the GLENTRONICS, INC. limited warranty (“warranty”) as set out below. Do not use your product until you have read the terms of the warranty. If you do not agree to the terms of the warranty, do not use the product and return it within the return period stated on your purchase receipt from the retail store or authorized distributor where you purchased it for a refund.

  • Page 16: Other Products

    Additional Products to Help Protect Your Basement Maintenance Free Battery Clenit Pump and Pro Series CONNECT Sewage Pump Pit Cleaner WiFi2 Module B12-100 E7055 PS-WiFi2 FEATURES AND BENEFITS: ƒ Sends emails, texts or push notifications Compatible with: and status alerts to your phone, tablet or computer ƒ...

Table of Contents