Sustainable Solutions caroma Somerton Smart Two Piece 829110 Installation Instructions

Somerton Smart Two Piece
1.28/0.8 gpf (4.8/3 lpf) Easy Height &
Elongated Vitreous China Dual Flush High
Efficiency (HET)Washdown Toilet
Left Lever Tank: #829110
Right Lever: #829110-R Bowl: #829109
Plumbers Installation Instructions
PLEASE READ CAREFULLY BEFORE INSTALLATION.
Rough in:
This toilet can be installed into a 10" or 12" rough in, by rotating the
offset adapter.
IMPORTANT:
Do not use a wax ring with a reducing horn on this toilet as it reduces
the flushing efficiency as shown in Fig.1.
Working Water Pressure:
USA & Canada: Recommended working water pressure 20-80psi
(140-550Kpa).
Flushing Operation:
Push down firmly the side lever handle for a full flush (1.28 gpf/4.8 lpf
and pull up for a reduced flush (0.8 gpf/3 lpf).
Installation Procedure:
1.
It is important for the installation of the Somerton Smart 2 PC washdown
bowl that the closet flange be accurately set out from the finished wall as
detailed in Fig.2.
2. Position wax ring and offset adaptor onto closet bolts as detailed in
Fig. 3 and 4, ensuring that the offset adaptor is positioned for
10" (255mm) or 12" (305mm) rough in as shown in Fig.7 below.
Place a fixing bracket (#687088) onto each closet bolt and hand tighten
3.
nuts and washers onto the closet bolts as detailed in Fig.4. Apply an
additional turn by wrench for final installation.
4. Ensure that the area around the closet bowl is clean and free from
building materials.
5. Accurately align the closet bowl over the offset adaptor and lower into
position.
6. Insert the plastic and brass bushings into the bowl fixing holes as shown
in Fig.5. Secure the bushings through the holes in fixing brackets with SS
screws as shown in Fig.6. Spacing between the outside of the Somerton
bowl and the fixing bracket can vary. To ensure the best possible installation
2 lengths of SS screws have been supplied. If when fastening there is no
resistance, (meaning that the screw has not sufficiently fastened into
the fixing bracket), substitute the longer 55mm (2
start with the longer hardware as you do not want the screws to insert past
the fixing bracket into the offset adaptor, as this can affect your seal. Cover
the holes with caps.
7. It is recommended that a bead of silicone caulking is applied fully around
base of the closet bowl, leaving 1-2" at the rear of the bowl.
8. Remove any excess silicone caulking.
Fig.7
Sustainable Solutions Vancouver, BC, Canada + Ferndale, WA, USA
Fig.1
Fig.3
3 / ") screws. Do not
16
Closet Bowl
Cap
SS Screw
Fig.5
360 mm
14-1/8"
140 mm
5-1/2"
360 mm
14-1/8"
Wax Ring with Plastic Reducing Horn
Finished Wall
Closet Bolt
Wax Ring
Closet Flange
Plastic
Bush
Brass Bush
270 mm
10-5/8"
25 mm (1")
255 mm
10"
305 mm
12"
Finished Wall
Closet Flange
Fig.2
Finished Wall
Adaptor
Fixing
Fig.4
Bracket
Fixing
Bracket
Fig.6
Date of Issue: March 2024