External Controls; Regulations And Safety Notices - Acer PM1 Series User Manual

External controls

Brightness
1
Up
Menu
2
OK
Volume
3
Down
SOURCE /
EXIT
4
5 LED Indicator

Regulations and safety notices

FCC notices
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful Interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device does
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
•
• Consult the dealer or an experienced radio/television technician for help.
CE declaration of conformity
Hereby, Acer Inc., declares that this LCD monitor is in compliance with the essential requirements and other
relevant provisions of EMC Directive 2014/30/EU, Low Voltage Directive 2014/35/EU, and RoHS Directive
2011/65/EU and Directive 2009/125/EC with regard to establishing a framework for the setting of ecodesign
requirements for energy-related product.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain compliance with
EMC regulations.
Notice: Peripheral devices
radio and TV reception.
1
2
3
5
4
a. Press this button to adjust the brightness diretly.
b. Press this button to select the desired item when in OSD menu.
a. Press this button to display the menu.
b.
a. Press this button to adjust the volume diretly.
b. Press this button to select the desired item when in OSD menu.
a. Press this to select signal channel.
b. In OSD menu, short time press to exit menu.
c.
d. Short time press this button to power On.
in OSD menu.
power saving mode.