ASROCK K10N78HSLI-1394 - V1.0 User Manual page 47

Secure Virtual Machine
This option appears only when you adopt AM2 CPU. When this option is set to
[Enabled], a VMM (Virtual Machine Architecture) can utilize the additional
hardware capabilities provided by AMD-V. The default value is [Enabled]. Con-
figuration options: [Enabled] and [Disabled].
Enhanced Halt State
C1E is an enhanced power saving state which is supported by AM2 dual core
and AM2+ multi-core processors. The processor will enter C1E power saving
state when both of its cores transition into the C1 state. The default value is
[Disabled]. Configuration options: [Enabled] and [Disabled].
Processor Maximum Frequency
It will display Processor Maximum Frequency for reference.
North Bridge Maximum Frequency
This option appears only when you adopt Phenom CPU. It will display North
Bridge Maximum Frequency for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Frequency and Processor Voltage. However, it is recom-
mended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Enhanced Halt State
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Processor Target Frequency
North Bridge Target Frequency
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Processor Frequency
This option appears only when you adopt AM2 CPU. This item will show when
"Multiplier/Voltage Change" is set to [Manual]; otherwise, it will be hidden. The
range of the value depends on the CPU you adopt on this motherboard. However,
for system stability, it is not recommended to adjust the value of this item.
Select the over clock
mode.
[Auto]
[200]
[100]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Disabled]
2300 MHz
Select Screen Select Screen
1800 MHZ
Select Item Select Item
1.2500 V
+- +- Change Option Change Option
[Manual]
F1 F1 General Help General Help
2300 MHz
F9 F9 Load Defaults Load Defaults
1800 MHZ
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
4 7 4 7 4 7 4 7 4 7